Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
ISSN: 0956-540X

hal-01187132
https://hal.archives-ouvertes.fr/hal-01187132

Éditeur(s) : HAL CCSD Optical Society of America
Résumé : This Letter describes a dual-amplitude modulation technique incorporated into a double reflection extrinsic-type fiber Fabry-Perot interferometer to measure periodic, nonperiodic as well as quasi-static displacements. The modulation scheme simultaneously maintains the interference signal pair in quadrature and provides a reference signal for displacements inferior to a quarter of the source wavelength. The control and phase demodulation of the interferometer carried out via software enable quasi-real-time measurement and facilitates sensor alignment. The sensor system can be exploited in the low frequency range from 10−3 to ∼500 Hz and has a resolution better than 2.2 nm, targeting applications in geophysics.
ISSN: 0146-9592

hal-00758140
https://hal.archives-ouvertes.fr/hal-00758140
DOI : 10.1364/OL.37.002886

Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : International audience
In this study we attempt to understand the water storage variations in a karst aquifer on the Larzac Plateau (South of France) using ground-based gravimetry. Surface to 60 m depth gravity measurements are performed three times a year since 2006 down a pothole, in complement to monthly absolute gravity (AG) measurements at three sites. The time variations of the surface to depth (STD) gravity differences are compared with the AG variations. Using a simple Bouguer plate model, we find that the STD gravity differences are very similar to the AG variations. The STD gravity differences are then used to determine apparent density values. These integrative density values are compared with measured grain densities from core samples to obtain an apparent porosity and saturation change representative of the investigated depth. The apparent porosity ranges from 4.8 to 7.3 per cent. We then discuss on the repartition of the apparent physical properties with respect to the epikarst and infiltration zone karst structures. We argue that AG and STD differences monitor epikarst water storage variations. Within this scope, we discuss the fact that seasonal scale water storage variation occurs predominantly in the epikarst.
ISSN: 0956-540X

hal-00413528
https://hal.archives-ouvertes.fr/hal-00413528
DOI : 10.1111/j.1365-246X.2009.04118.x

Éditeur(s) : HAL CCSD Springer-Verlag
Résumé : International audience
High-resolution borehole strainmeters are usually installed in tectonically active regions in order to detect slow-slip events, and to estimate slow transients related to earthquake swarms. However, they are also sensitive to other numerous influences, internal or external. Furthermore, the quality of their coupling to the rock through cementation, and the mechanical properties of the rock mass around them, have a critical influence on their records. Many of the existing strainmeters present such problems, and the correction for these effects often remains a challenge. In this paper, we present the analysis of the records of a high-resolution borehole dilatometer (Sacks–Evertson), located in the seismically active rift of Corinth (Greece) (station TRZ in the Trizonia island). We show that the instrument suffers from an only partial-solid coupling, and that the nearby sea tides have a direct (through elastic response) and indirect (through pore-pressure diffusion) effect on the dilatation signal, which adds up to the solid tidal strain source. We propose a methodology that allows, in a first step, to better separate the internal (solid tide) from the external (air pressure, sea level) influences, by calculating a frequency-dependent transfer function outside the range of the tidal periods. We then extrapolate this function, in particular at the tidal periods. In a second step, the resulting variation with frequency of the coupling coefficients with sea level led us to estimate the proportion of instrument not solidly cemented to rock (thus in contact with water pore pressure), which is about 90 % of the total height. Despite the small proportion of solid coupling, the sensor resolution remains very good up to a few tens of hours of a time period, thanks to the confining effects of the rocks on the local pore pressure. These results allow us to correct for the external effects, and reduce the associated variance by 80–90 % (in the period range of minutes to days). The empirical correction of the sea level effect could be explained using a simple Boussinesq’s approximation and 1D pore-pressure diffusion model, which contributed to better constraint of some of the poro-elastic parameters in the vicinity of the instrument. After correction, the solid tidal signal at the 24-h period is almost anti-correlated with those of the theoretical solid tide. This surprising result is consistent with a similar anti-correlation observed for the longest period surface waves (200 s) comparing the TRZ dilatometer signals to the strain measured by a nearby borehole strainmeter (MOK, 15 km). This could be related to the presence of a shallow fault close to the instrument, which would creep in response to seismic wave-related stress.
ISSN: 0033-4533

hal-01122853
https://hal.archives-ouvertes.fr/hal-01122853
DOI : 10.1007/s00024-013-0742-2