Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
Observations from deep boreholes at several locations worldwide, laboratory measurements of frictional strength on quartzo-feldspathic materials, and earthquake focal mechanisms indicate that crustal faults are strong (apparent friction μ ≥ 0.6). However, friction experiments on phyllosilicate-rich rocks and some geophysical data have demonstrated that some major faults are considerably weaker. This weakness is commonly considered to be characteristic of mature faults in which rocks are altered by prolonged deformation and fluid-rock interaction (i.e., San Andreas, Zuccale, and Nankai Faults). In contrast, in this study we document fault weakening occurring along a marly shear zone in its infancy (<30 m displacement). Geochemical mass balance calculation and microstructural data show that a massive calcite departure (up to 50 vol %) from the fault rocks facilitated the concentration and reorganization of weak phyllosilicate minerals along the shear surfaces. Friction experiments carried out on intact foliated samples of host marls and fault rocks demonstrated that this structural reorganization lead to a significant fault weakening and that the incipient structure has strength and slip behavior comparable to that of the major weak faults previously documented. These results indicate that some faults, especially those nucleating in lithologies rich of both clays and high-solubility minerals (such as calcite), might experience rapid mineralogical and structural alteration and become weak even in the early stages of their activity.
ISSN: 0278-7407

hal-01211481
https://hal.archives-ouvertes.fr/hal-01211481
DOI : 10.1002/2014TC003716

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Probabilistic seismic hazard analyses (PSHA) are commonly based on frequency magnitude statistics from 50-100 yearlong earthquake catalogs, assuming that these statistics are representative of the longer-term frequency of large earthquakes. We test an alternative PSHA approach in continental western Canada, including adjacent areas of northwestern U. S. A., using regional strain rates derived from 179 Global Positioning System (GPS) horizontal velocities. GPS strain rates are converted to earthquake statistics, seismic moment rates, and ground shaking probabilities in seismic source zones using a logic-tree method for uncertainty propagation. Median GPS-based moment rates and shaking estimates agree well with those derived from earthquake catalogs in only two zones (Puget Sound and mid-Vancouver Island). In most other zones, median GPS-based moment rates are 6-150 times larger than those derived from earthquake catalogs (shaking estimates 2-5 times larger), although the GPS-based and catalog estimates commonly agree within their 67% uncertainties. This discrepancy may represent an under-sampling of long-term moment rates and shaking by earthquake catalogs in some zones; however a systematic under-sampling is unlikely over our entire study area. Although not demonstrated with a high confidence level, long-term regional aseismic deformation may account for a significant part of the GPS/catalog discrepancy and, in some areas, represent as much as 90% of the total deformation budget. In order to integrate GPS strain rates in PSHA models, seismic versus aseismic partitioning of long-term deformation needs to be quantified and understood in terms of the underlying mechanical processes.
ISSN: 0148-0227

hal-00689004
https://hal.archives-ouvertes.fr/hal-00689004
DOI : 10.1029/2011JB008213

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
In orogenic systems, thrust faults play a major role in stacking different tectonic units and may act as conduits for the expulsion of large amounts of fluid of different origins (metamorphic, diagenetic, meteoric). This study focuses on the Monte Perdido thrust unit emplaced in the Paleogene Jaca thrust-sheet-top basin, in the SW-central Pyrenees. We aim to decipher the mechanisms and P-T conditions of deformation in fault zones and characterize the related fluid involvement, through combined microstructural, geochemical and microthermometry analyses. Two thrust faults cutting platform limestones, marls and siliciclastic turbidites of the lower part of the basin-fill (Paleocene-lower Eocene) have been studied. The fault zones are characterized by metre-thick shear zones with highly deformed, foliated clay-rich sediments. Foliation is underlined by preferentially oriented phyllosilicates. Several generations of shear and extension calcite, quartz and chlorite-bearing veins attest to fluid-rock interactions during a multi-stage deformation. Microstructural observations and stable isotope analyses on calcite from veins and host sediments suggest that deformation was aseismic and dominated by diffusive mass transfer from pressure solution sites along cleavage and stylolites to the precipitation sites in veins, with mineralizing fluids in equilibrium with the host sediments. Our results suggest an essentially closed hydrologic system, and imply the absence of significant fluid flow along the studied fault zones. Microthermometric study on fluid inclusions present in calcite and quartz veins, and calcite-quartz oxygen isotopic fractionation determined for the first generation shear veins, allow a geothermal gradient of 34 degrees C/km to be estimated. Analytical results demonstrate an evolution of the fault zones in three stages. The first stage was related to the emplacement of the Monte Perdido thrust unit during the middle Eocene at a temperature of similar to 208 degrees C and a burial depth of similar to 5.7 km. The second stage corresponds to a fault reactivation at a temperature of similar to 240 degrees C and a burial depth of similar to 6.5 km. The latter deformation may have been related to folding of the Monte Perdido thrust unit during the emplacement of the underlying Gavarnie thrust unit during the late Eocene-early Oligocene, with deeper burial resulting from aggradation of the thrust-sheet-top basin-fill. The last event corresponds to the formation of a dilatant vein system likely related to the exhumation of the massif.
ISSN: 0191-8141

hal-00644828
https://hal.archives-ouvertes.fr/hal-00644828
DOI : 10.1016/j.jsg.2011.06.006

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We present evidence that GPS velocity estimates of plate motions and fault slip rates agree to within uncertainties with geologic estimates during the most recent phase of the geologic evolution of the E Mediterranean region (post-Late Miocene). On this basis, we use the GPS differential velocities to estimate the timing of initiation of the principal structures in NW Turkey, the N Aegean Sea, and central Greece, including, the Marmara Sea, the Gulfs of Evia (GoE) and Corinth (GoC). and the Kephalonia Transform fault (KTF). We interpret these ages to indicate that the North Anatolian fault propagated across the N Aegean, opening the GoE and GoC and initiating the KTF, during the past 1-4 Ma. We further suggest that Aegean extension that was earlier more distributed across the Aegean Basin became focused on this new fault system allowing the southern Aegean and Peloponnisos to translate SW with little internal deformation, as observed today with GPS. This change in tectonic configuration may account for the clear geologic evidence for crustal thinning throughout the S Aegean in apparent contradiction with low present-day strain rates. We further show that the low present-day strain rate along the southern edge of the Aegean micro-plate requires substantial aseismic slip along the plate interface below Crete, consistent with the low level of historic, subduction-type earthquakes along this segment of the subduction zone.
ISSN: 0040-1951

hal-00512634
https://hal.archives-ouvertes.fr/hal-00512634
DOI : 10.1016/j.tecto.2009.05.027

Éditeur(s) : HAL CCSD Nature Publishing Group
Résumé : International audience
Temperature and fluid pressure conditions control rock deformation and mineralization on geological faults, and hence the distribution of earthquakes1. Typical intraplate continental crust has hydrostatic fluid pressure and a near-surface thermal gradient of 31 ± 15 degrees Celsius per kilometre2, 3. At temperatures above 300–450 degrees Celsius, usually found at depths greater than 10–15 kilometres, the intra-crystalline plasticity of quartz and feldspar relieves stress by aseismic creep and earthquakes are infrequent. Hydrothermal conditions control the stability of mineral phases and hence frictional–mechanical processes associated with earthquake rupture cycles, but there are few temperature and fluid pressure data from active plate-bounding faults. Here we report results from a borehole drilled into the upper part of the Alpine Fault, which is late in its cycle of stress accumulation and expected to rupture in a magnitude 8 earthquake in the coming decades4, 5. The borehole (depth 893 metres) revealed a pore fluid pressure gradient exceeding 9 ± 1 per cent above hydrostatic levels and an average geothermal gradient of 125 ± 55 degrees Celsius per kilometre within the hanging wall of the fault. These extreme hydrothermal conditions result from rapid fault movement, which transports rock and heat from depth, and topographically driven fluid movement that concentrates heat into valleys. Shear heating may occur within the fault but is not required to explain our observations. Our data and models show that highly anomalous fluid pressure and temperature gradients in the upper part of the seismogenic zone can be created by positive feedbacks between processes of fault slip, rock fracturing and alteration, and landscape development at plate-bounding faults.
ISSN: 0028-0836

hal-01685757
https://hal.archives-ouvertes.fr/hal-01685757
DOI : 10.1038/nature22355

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We report preliminary results of a seismological experiment, SEISMOTANZ'07, which consisted in the deployment of a local network (35 stations) in the East African Rift System (EARS), North Tanzania, during 6 months in 2007. We compare two earthquake sequences (Gelai and Manyara) occurring respectively in the southern end of the Kenya rift and in the North Tanzanian Divergence (NTD). Only distant of 150 km, their triggering mechanisms are different. None of the sequences depicts typical swarm or mainshock-aftershock patterns. They highlight the change in the magmatic/tectonic nature of the rift where the eastern branch of the EARS enters the Tanzanian craton. The similar shape and long-axis of the elongate sequences emphasize the preferred locus of active strain release along NE-SW discontinuities which probably root at depth into steep Proterozoic shear zones. At Gelai, the deformation is dominated by aseismic process involving slow slip on normal fault and dyke intrusion within the upper crust Calais_et_al_2008. The spatial and temporal earthquake distribution indicates a possible correlation between the Gelai crisis and the eruption of the nearby Oldoinyo Lengai volcano. At Manyara, the sequence is more uncommon, revealing a long-lasting seismic activity deepely rooted (20-35 km depth) possibly related to stress loading transmitted laterally. The yield stress envelope modelled from the depth frequency distribution of earthquakes in the NTD is consistent with the presence of a mafic lower crust and further supports the strength increase of the rifted crust from south Kenya to the NTD.
ISSN: 0899-5362

hal-00420599
https://hal.archives-ouvertes.fr/hal-00420599
DOI : 10.1016/j.jafrearsci.2009.09.005

Éditeur(s) : HAL CCSD Société géologique de France
Résumé : International audience
In this paper, we provide the first structural map of Les Saintes archipelago (Guadeloupe, Lesser Antilles). The finite strain pattern displays four families of fault systems characterized by their statistical structural orientations: N000-N020, N050-N070, N090-N110 and N130-N140 trending fault systems. Our onshore results thus underline a fault network much more complex than the one depicted by the previous offshore geophysical investigations around Les Saintes archipelago, which show only N120-N150 trending system. According to the available K-Ar dating of the volcanic rocks and the relative chronology of the faults defined in the field, we determine the deformation history in Les Saintes islands since the last 3 Ma. The four highlighted trending fault systems are already active since the Pliocene and are consistent with the present-day extensional tectonics in the Guadeloupe archipelago compatible with the reactiva-tion of inherited structures at the active arc scale. We interpret the tectonic evolution of Les Saintes islands as the result of interplay between subduction of aseismic ridges (Tiburon and Barracuda ridges) and oblique convergence. Furthermore , we recognized an exhumed geothermal paleo-system in Terre-de-Haut island which is a good analogue of the present-day active Bouillante geothermal system. Its duration is estimated at 400 k.y. during the Pliocene.
EISSN: 1777-5817

hal-01625778
https://hal.univ-antilles.fr/hal-01625778
https://hal.univ-antilles.fr/hal-01625778/document
https://hal.univ-antilles.fr/hal-01625778/file/VeratIEtAl_Final.pdf
DOI : 10.2113/gssgfbull.187.1.3