Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Laboratory models have been conducted to improve our understanding of the role that the resistance of the slab to bending and its coupling to the ambient mantle play in subduction dynamics over geological time scales. Our models are set up with a viscous plate of silicone (lithosphere) subducting under negative buoyancy in a viscous layer of glucose syrup (mantle). For our study, the lithosphere/upper mantle viscosity contrast has been systematically varied, from similar to 10 to similar to 10(5) in order to explore the parameter space between weak and strong slab dynamics. We found that subduction is characterized by a retreating mode for viscosity ratios > 10(4), by the coexistence of a retreating mode and an advancing mode for viscosity ratios between similar to 10(4) and similar to 10(2), and quasi-stationary, Rayleigh-Taylor like behaviour for ratios < 10(2). By combining our experimental results and kinematic data from current subduction zones in four reference frames which differ in the amount of net rotation, we infer that a lithosphere/upper mantle viscosity contrast of 150-500 is necessary to obtain realistic trench/subducting plate velocity ratios as well as the variability of subduction styles observed in nature.
ISSN: 0012-821X

hal-00412008
https://hal.archives-ouvertes.fr/hal-00412008
DOI : 10.1016/j.epsl.2008.04.006

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
New estimates of trench migration rates allow us to address the dynamics of trench migration and back-arc strain. We show that trench migration is primarily controlled by the subducting plate velocity V-sub, which largely depends on its age at the trench. Using the hot and weak arc to back-arc region as a strain sensor, we define neutral arcs characterized by the absence of significant strain, meaning places where the forces (slab pull, bending, and anchoring) almost balance along the interface between the plates. We show that neutral subduction zones satisfy the kinematic relation between trench and subducting plate absolute motions: V-t = 0.5V(sub) - 2.3 (in cm a(-1)) in the HS3 reference frame. Deformation occurs when the velocity combination deviates from kinematic equilibrium. Balancing the torque components of the forces acting at the trench indicates that stiff (old) subducting plates facilitate trench advance by resisting bending.
ISSN: 0278-7407

hal-00411731
https://hal.archives-ouvertes.fr/hal-00411731
https://hal.archives-ouvertes.fr/hal-00411731/document
https://hal.archives-ouvertes.fr/hal-00411731/file/Lallemand2008-Tectonics.pdf
DOI : 10.1029/2007TC002212

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Recent global kinematic studies reveal that most of the trenches roll back but a significant number of them advance toward the upper plate. Those advancing trenches are mostly located in the Western Pacific and correspond to the subduction of very old, Mesozoic oceanic lithosphere. While retreating trenches are commonly explained by the slab pull action of the descending lithosphere, the origin of advancing trenches is still debated. Since this relationship is dependent upon the adopted reference frame, we select region where geological studies show the variability of trench migration style with time. The Izu-Bonin-Mariana (IBM) region represents a key example. The detailed reconstruction of the trench migration of the IBM subducting system reveals that after a long episode of asymmetric rollback, the IBM trench recently started advancing. We propose that this change from retreating to advancing trench mode results from the subduction of progressively older and stiffer lithospheric material. We test this hypothesis by means of two-dimensional (2-D) numerical models, reproducing the effects of the lithospheric aging during subduction. The result of our numerical tests shows that the entrance of old and stiff lithosphere forces the trench to advance because the increasing stiffness of the slab prevents the slab to unbend once it has subducted. We adapt this physical result to the IBM evolution, showing that the switch from trench retreat to trench advance can reconcile the shape of IBM slab as previously suggested. Finally we discuss the possibility that the subduction of the Cretaceous lithosphere might have triggered the change of the motion of the Pacific plate around 5 Ma.
ISSN: 0012-821X

hal-00455988
https://hal.archives-ouvertes.fr/hal-00455988
DOI : 10.1016/j.epsl.2009.09.042

Éditeur(s) : HAL CCSD Elsevier
Résumé : A combination of statistical studies on present-day subduction zones and three-dimensional (3D) laboratory models is performed with the aim to clarify the way that plate kinematics control the geometry of the slab and the overriding plate deformation in subduction zones. In 3D laboratory models, the analogue of a two layer linearly viscous lithosphere–upper mantle system is achieved by means of silicon putty glucose syrup tank experiment. The subducting and overriding plate velocities are systematically changed by exploring the variability field of natural plate kinematics. Both statistical and modelling approaches recognize the importance of overriding plate motion on subduction process behavior: (1) trenches migrate at a rate close to the overriding plate motion, but always move slower than the overriding plates. The mechanism at work is a direct consequence of “slab anchoring” opposed by both lithosphere and mantle viscous resistance and is responsible for overriding plate deformation and slab geometry variability. (2) An overriding plate shortens when the overriding plate moves toward the trench and conditions that are favourable for overriding plate extension are created when the overriding plate moves away from the trench. (3) Shallow and steep dips are found if the overriding plate moves toward and away from the trench, respectively.
ISSN: 0012-821X

hal-00406598
https://hal.archives-ouvertes.fr/hal-00406598
DOI : 10.1016/j.epsl.2007.02.004

Éditeur(s) : HAL CCSD Taylor & Francis
Résumé : International audience
ternational Ocean Discovery Program (IODP) Expedition 352 recovered a high-fidelity record of volcanism related to subduction initiation in the Bonin fore-arc. Two sites (U1440 and U1441) located in deep water nearer to the trench recovered basalts and related rocks; two sites (U1439 and U1442) located in shallower water further from the trench recovered boninites and related rocks. Drilling in both areas ended in dolerites inferred to be sheeted intrusive rocks. The basalts apparently erupted immediately after subduction initiation and have compositions similar to those of the most depleted basalts generated by rapid sea-floor spreading at mid-ocean ridges, with little or no slab input. Subsequent melting to generate boninites involved more depleted mantle and hotter and deeper subducted components as subduction progressed and volcanism migrated away from the trench. This volcanic sequence is akin to that recorded by many ophiolites, supporting a direct link between subduction initiation, fore-arc spreading, and ophiolite genesis.
ISSN: 0020-6814

hal-01685628
https://hal.archives-ouvertes.fr/hal-01685628
DOI : 10.1080/00206814.2016.1276482

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
We use digital elevation models and satellite imagery data completed with field observations to develop an integrated morphotectonic analysis of the anomalous topography of the Central Cordillera of Patagonia between 46 degrees S and 48 degrees S, in a region overlying subducted segments of the Chile Spreading Ridge. This region shows a number of peculiar features, not expected in a normal subduction-related belt located away from a buried spreading center. First, it is characterized by overall short-wavelength topography and highly contrasted reliefs, typical of deeply incised young mountain belts, but surprisingly, also by an average very low elevation of similar to 900 m. Second, the Cordillera lacks central high reliefs; instead, there is a central, depressed domain with average low slope gradients including the deepest point of the study area (300 m below sea level in the bottom of Lake General Carrera/Buenos Aires). This depressed area is flanked by western and eastern regions of higher elevation having opposite general slope dips. To the east, the central Patagonian Cordillera is now separated from the flat plains of the Pampean domain (representing its former piedmont) and several elevated basaltic plateaus (mesetas) by 160 degrees N-180 degrees N trending morphotectonic corridors and the western border scarps of the mesetas. These scarps correspond to neotectonic features controlled by recent vertical faults, mostly active after 3 Ma. Remnants of a former peneplain, the Avellanos surface, are widespread within the entire Cordilleran region. From geological evidence, this peneplain formed between 15 and 4 Ma and was connected originally with the mesetas domain and now is dissected by these corridors. It is shown that a negative inversion related to extensional and strike-slip faulting occurred in the frontal region of the Cordillera at 3 Ma synchronously with the emplacement of magmatic products. Timing of the extensional deformation in central Patagonia is concomitant with the migration at depth of different segments of the South Chile Ridge, which entered the trench at 6 and 3 Ma, respectively, and the consequent opening of a slab window allows asthenospheric hot mantle to reach lithospheric regions. Finally, migration of segments of the Chile Spreading Ridge since 6 Ma triggered regional uplift of the Cordillera followed by limited extension in relation with increased thermal weakening of the crust.
ISSN: 0278-7407

hal-00486334
https://hal.archives-ouvertes.fr/hal-00486334
DOI : 10.1029/2009TC002453