Éditeur(s) : HAL CCSD Oxford University Press (OUP)
Résumé : Geodynamic models incorporating metamorphic phase transformations almost invariably assume the validity of the Boussinesq approximation that violates conservation of mass. In such models metamorphic density changes take place without volumetric effects. We assess the impact of the Boussinesq approximation by comparing models of orogeny accompanied by lower crustal eclogitization both with and without the approximation. Our results demonstrate that the approximation may cause errors approaching 100 per cent in characteristic measures of orogenic shape. Mass conservation errors in Boussinesq models amplify with model time. Mass conservative models of metamorphism are therefore essential to understand long-term tectonic evolution and to assess the importance of the different geodynamic processes.
ISSN: 0956-540X

hal-00617480
https://hal.archives-ouvertes.fr/hal-00617480
DOI : 10.1111/j.1365-246X.2011.05052.x

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
We investigate flexural geometry and rheology of the India plate beneath the eastern Himalaya from a new gravity data set acquired in Bhutan. Compared to the well‒studied Nepal Himalaya, the obtained Bouguer anomaly profiles across the range show shorter wavelength flexure of the lithosphere with a narrower and shallower foreland basin. This new data set and seismic Moho constraints are interpreted together in terms of lithospheric flexure using a 2‒D thermomechanical model. Our results suggest that the strongest layer of the continental lithosphere beneath Bhutan is the upper mantle, as it is beneath Nepal. The observed west‒to‒east decrease in flexural wavelength is associated with weakening mantle rheology. The simulations show that this decrease can be related to ductile mantle behavior: either hydrated wet dunite or dry and hot olivine rheology. Both models display decoupled lithospheric layers leading to an eastward decrease of flexural rigidity from ∼1024 to ∼5*1022 N m in Nepal and Bhutan, respectively.
ISSN: 0094-8276

hal-00903564
https://hal.archives-ouvertes.fr/hal-00903564
DOI : 10.1002/grl.50793

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
We performed 31 friction experiments on glassy basalts (GB) and glass-free basalts (GFB) at slip rates up to 6.5 m s−1 and normal stress up to 40 MPa (seismic conditions). Frictional weakening was associated to bulk frictional melting and lubrication. The weakening distance (Dw) was about 3 times shorter in GB than in GFB, but the steady state friction was systematically higher in GB than in GFB. The shorter Dw in GB may be explained by the thermal softening occurring at the glass transition temperature (Tg ~500°C), which is lower than the bulk melting temperature (Tm ~1250°C) of GFB. Postexperiment microanalyses suggest that the larger crystal fraction measured in GB melts results in the higher steady state friction value compared to the GFB melts. The effect of interstitial glass is to facilitate frictional instability and rupture propagation in GB with respect to GFB.
ISSN: 0094-8276

hal-01054139
https://hal.archives-ouvertes.fr/hal-01054139
DOI : 10.1002/2013GL058601

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Strain and strain rate partitioning in partially molten rocks are two of the important mechanisms that govern the process of coupling and/or decoupling of the partially molten lithosphere. Consequently, the proportion of partial melt and crystals and their network in partially molten rocks influence the degree of the partitioning along with the bulk rheology of the system. This study explores the possible role of finite strain and strain rate on the rate and volume of partial melting and crystallization in a metapelitic system undergoing deformation. Cylinders of synthetic quartz-muscovite aggregate (7: 3 volume ratio) were deformed in torsion at 750 C, 300 MPa and constant shear strain rate ((gamma) over dot = 3 x 10(-4) s(-1)) for finite shear strains (gamma) 1-15. The deformed samples were studied along the longitudinal tangential ( LT) and axial ( LA) sections to obtain the data along a range of strain rates for a given finite strain and vice versa. The results showed that deformation plays an important role on the kinetics of partial melting and crystallization. With increasing strain rate, amount and rate of crystallization comprise the volumetrically dominant process compared to partial melting at a given finite strain. In contrast, when the strain rate is constant, partial melting is the dominant process over crystallization up to moderate strain (gamma < 5). The dominant process reverses at higher strain, and the system shows more crystallization than partial melting. Application of the experimental data to geological systems implies that for metapelites a significant amount (similar to 20%) of partial melt can generate at high strain rate and moderate strain (gamma similar to 7), but at high strain (gamma = 15) the system is melt depleted. Under such conditions, decoupling should take place in brittle-ductile mode. On the other hand, rocks undergoing deformation with low strain rates and strain (gamma < 3) contain more than 25% partial melt, which can act as a major decoupling agent by localizing ductile shear zones.
ISSN: 0148-0227

hal-00617714
https://hal.archives-ouvertes.fr/hal-00617714
DOI : 10.1029/2010JB007865

Éditeur(s) : HAL CCSD Geological Society of London
Résumé : International audience
Low-velocity zones ('bright spots') imaged by the INDEPTH seismic experiment in southern Tibet are extensively interpreted as widespread partial melt within the crust, which has given a strong support for the channel flow model. These suggest that a continuous seismic low-velocity zone underlies Tibet on the large scale. Here we take advantage of the Hi-CLIMB seismic experiment which includes a dense south-north profile and a lateral 2D seismic network to assess the vertical and the horizontal extension of low-velocity zones in southern Tibet. Several approaches including migration, amplitude analysis and waveform inversion of receiver functions are performed to detect crustal low-velocity zones using this new seismological dataset. Our results reveal localized and discontinuous low-velocity zones in Tibet. They indicate that the vertical extension of the low-velocity zones is about 10 km, and their maximum horizontal length appears to be c. 50 km. Our study suggests a partial correlation between the location of these low-velocity zones and the spatial distribution of Tibetan grabens. These results, especially the non-continuity of low-velocity zones, together with the observed regular value of mean crustal VP/VS ratio, question the existence of widespread partial melt of the southern Tibetan crust and, therefore, the viability of the channel flow model.
Growth and Collapse of the Tibetan Plateau

hal-00853971
https://hal.archives-ouvertes.fr/hal-00853971
DOI : 10.1144/SP353.6

Éditeur(s) : HAL CCSD Wiley-Blackwell
Résumé : International audience
In Alpine Corsica (France), deeply subducted metabasalts are well preserved as lawsonite-bearing eclogite (Law-Ecl), occurrence of which is restricted to similar to 10 localities worldwide. The Corsican Law-Ecl, consisting of omphacite + lawsonite + garnet + phengite + titanite, occurs as both single undeformed metabasaltic pillows surrounded by lawsonite blueschist (Law-Bs), and carbonate-bearing eclogitic veins. Law-Bs are found as variably deformed metabasaltic pillows locally cross-cut by eclogitic veins and consist of glaucophane + actinolite + lawsonite + garnet + phengite + titanite. Field evidence and microstructures reveal that both Law-Ecl and Law-Bs are stable at the metamorphic peak in the lawsonite-eclogite stability field. Isochemical phase diagrams (pseudosections) calculated for representative Law-Ecl and Law-Bs samples indicate that both lithologies equilibrated at the same conditions of similar to 520 +/- 20 degrees C and 2.3 +/- 0.1 GPa. Therefore, the coexistence at the same peak metamorphic conditions of Law-Ecl and Law-Bs implies that different portions of deeply subducted oceanic crust may store significantly different H2O contents, depending on bulk-rock chemical composition. In addition, thermodynamic modelling of phase equilibria indicates that the occurring progressive dehydration reactions, which are significantly depending on bulk-rock chemical composition, strongly influence rock densification and eclogite formation in subducting slabs.
ISSN: 0263-4929

hal-00617768
https://hal.archives-ouvertes.fr/hal-00617768
DOI : 10.1111/j.1525-1314.2011.00931.x

Éditeur(s) : HAL CCSD Landes Bioscience
Résumé : International audience
In 2008 we published the first set of guidelines for standardizing research in autophagy. Since then, research on this topic has continued to accelerate, and many new scientists have entered the field. Our knowledge base and relevant new technologies have also been expanding. Accordingly, it is important to update these guidelines for monitoring autophagy in different organisms. Various reviews have described the range of assays that have been used for this purpose. Nevertheless, there continues to be confusion regarding acceptable methods to measure autophagy, especially in multicellular eukaryotes. A key point that needs to be emphasized is that there is a difference between measurements that monitor the numbers or volume of autophagic elements (e.g., autophagosomes or autolysosomes) at any stage of the autophagic process vs. those that measure flux through the autophagy pathway (i.e., the complete process); thus, a block in macroautophagy that results in autophagosome accumulation needs to be differentiated from stimuli that result in increased autophagic activity, defined as increased autophagy induction coupled with increased delivery to, and degradation within, lysosomes (in most higher eukaryotes and some protists such as Dictyostelium) or the vacuole (in plants and fungi). In other words, it is especially important that investigators new to the field understand that the appearance of more autophagosomes does not necessarily equate with more autophagy. In fact, in many cases, autophagosomes accumulate because of a block in trafficking to lysosomes without a concomitant change in autophagosome biogenesis, whereas an increase in autolysosomes may reflect a reduction in degradative activity. Here, we present a set of guidelines for the selection and interpretation of methods for use by investigators who aim to examine macroautophagy and related processes, as well as for reviewers who need to provide realistic and reasonable critiques of papers that are focused on these processes. These guidelines are not meant to be a formulaic set of rules, because the appropriate assays depend in part on the question being asked and the system being used. In addition, we emphasize that no individual assay is guaranteed to be the most appropriate one in every situation, and we strongly recommend the use of multiple assays to monitor autophagy. In these guidelines, we consider these various methods of assessing autophagy and what information can, or cannot, be obtained from them. Finally, by discussing the merits and limits of particular autophagy assays, we hope to encourage technical innovation in the field.
Autophagy

hal-00735751
https://hal.archives-ouvertes.fr/hal-00735751
PUBMED : 22966490

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Torsion experiments (inline image =3 × 10−4 s−1) were performed to investigate the large strain (γmax = 15) rheology on quartz-muscovite aggregate as analogue to pelitic rocks undergoing melting and crystallization during deformation at 300 MPa confining pressure and 750°C temperature. Microstructures reveal four distinct but gradational stages of crystal-melt interactions during deformation--(a) solid state deformation, (b) initiation and domination of partial melting, (c) simultaneous partial melting and crystallization, and (d) domination of crystallization. The microstructural stages are linked to the rheology of the deforming samples. Partial melting starts at relatively low finite shear strains (γ = 1-3) showing approximately 60% strain softening. At γ = 4-10 the partially molten bulk material shows a steady state flow at low stress. Further crystallization of new crystals at the expense of melt between γ = 10 and 15 causes weak strain hardening until the material fails by developing brittle fractures. The stress exponent (n), calculated at γ = 1, 5, and 10, increases from ∼ 3 to ∼ 43, indicating a transition from power to power law breakdown or exponential flow of the bulk system. Hydrostatic experiments for equivalent times and conditions of the torsion experiments were also conducted to evaluate the reaction kinetics and microstructures under static conditions. The new experimental data establish that partially molten rock does not flow according to a constant strain rate-dependent power law (steady state) rheology. The rheological transition from strain rate sensitive to strain rate insensitive flow is interpreted as a function of melt-crystal ratio, their mutual interactions, and the evolution of microstructures in the partially molten rock.
ISSN: 0148-0227

hal-01053709
https://hal.archives-ouvertes.fr/hal-01053709
DOI : 10.1002/2013JB010777

Éditeur(s) : HAL CCSD American Geophysical Union (AGU) American Geophysical Union
Résumé : International audience
The brittle to ductile transition may strongly influence hydraulic properties of rocks at the depth and temperature ranges that hydrothermal fluids circulate. To examine this transition in the context of the oceanic crust, we conducted a series of deformation experiments on a natural basalt sample at in situ oceanic crust conditions. Dilatancy was measured during deformation. The method consisted in monitoring the volume of pore fluid that flows into or out of the sample at constant pore pressure. Mechanical and microstructural observations at experimental constant strain rate of 10−5 s−1 indicated that the basalt was brittle and dilatant up to 800°C. At higher temperature, the deformation mode became macroscopically ductile and samples compacted. These observations have important implications on heat transfer and fluid migration in oceanic crust.
ISSN: 0094-8276

hal-01172352
https://hal.archives-ouvertes.fr/hal-01172352
DOI : 10.1002/2015GL063437