Manioc : Portail | resultats 41 - 54 pour la recherche: Sedimentary architecture

The 2.1 Ga-old injectite network of the Franceville Basin, Gabon: Architecture, origin and implications on manganese mineralization
Auteur(s) : DUBOIS, Manon LOPEZ, Michel Orberger, Beate GAY, Aurelien Moussavou, Mathieu Pambo, Florent Rodrigues, Sophie
Auteurs secondaires : Géosciences Montpellier ; Université des Antilles et de la Guyane (UAG) - Institut national des sciences de l'Univers (INSU - CNRS) - Université de Montpellier (UM) - Centre National de la Recherche Scientifique (CNRS) Géosciences Paris Sud (GEOPS) ; Université Paris-Sud - Paris 11 (UP11) - Centre National de la Recherche Scientifique (CNRS) Université des sciences et techniques de Masuku, Franceville COMILOG SA, Moanda

Éditeur(s) : HAL CCSD Elsevier
Résumé : Detailed sedimentological investigations on numerous outcrops and drill-core sections in the 2.1-Ga-old Franceville basin, Gabon, provide evidence for a large-scale injectite network. The injectites were formed by the injection of sands through a thickness of about 150 m of the FB1 Member, and now cover a minimum area of 70 km2 corresponding to the Bangombé plateau, but are also recognized close to Franceville 35 km farther south-east. The injectite lithology corresponds to a mud- or carbonate-supported sandstone characterized by a loose and uncompacted fabric contrasting with the host-rock. Because the injectites are often parallel to subparallel to the stratification, they were misinterpreted as depositional beds by previous authors. At outcrop, the injectite bodies exhibit sill, dyke, wing and protrusive geometries emplaced during early burial within poorly compacted material, with partial wall erosion and dissociation. The source of the sand material is attributed to a channel-levee turbidite depositional system located in the lower part of the FB1 Member. These deposits were buried by a thick biochemical muddy cap deposited during a starvation phase, which increased the seal capacity of the system. This type of architecture has a high potential to develop compaction disequilibrium during burial. Moreover, in the case of the Francevillian injectites, the abundance of microbial organic matter favoured early methane degassing and lateral charging of the sand reservoir. The overpressure in the channels was periodically released during early burial, through the effect of rapid sedimentary and tectonic loading, and possible seismic activity. The fluidized sand was injected according to a symmetrical wing pattern. Thus, the injected masses caused a local decrease in the grade of the lateritic manganese ore deposit of the Bangombé plateau.
ISSN: 0301-9268

hal-01667217
https://hal.archives-ouvertes.fr/hal-01667217
DOI : 10.1016/j.precamres.2017.09.022

| Plus

Holocene evolution of a Languedocian lagoonal environment controlled by inherited coastal morphology (northern Gulf of Lions, France)
Auteur(s) : Raynal, Olivier Bouchette, Frederic Certain, Raphael Sabatier, Pierre Lofi, Johanna Seranne, Michel Dezileau, Laurent Briqueu, Louis
Auteurs secondaires : Géosciences Montpellier ; Université des Antilles et de la Guyane (UAG) - Institut national des sciences de l'Univers (INSU - CNRS) - Université de Montpellier (UM) - Centre National de la Recherche Scientifique (CNRS)

| Plus

Late Paleoproterozoic (1900–1800 Ma) nappe stacking and polyphase deformation in the Hengshan–Wutaishan area: Implications for the understanding of the Trans-North-China Belt, North China Craton
Auteur(s) : Trap, Pierre Faure, Michel Lin, Wei Monié, Patrick
Auteurs secondaires : Institut des Sciences de la Terre d'Orléans (ISTO) ; Institut national des sciences de l'Univers (INSU - CNRS) - Université d'Orléans (UO) - Centre National de la Recherche Scientifique (CNRS) State Key Laboratory of Lithospheric Evolution ; Institute of Geology and Geophysics, Chinese Academy of Sciences Géosciences Montpellier ; Université des Antilles et de la Guyane (UAG) - Institut national des sciences de l'Univers (INSU - CNRS) - Université de Montpellier (UM) - Centre National de la Recherche Scientifique (CNRS) National Science Foundation of China grant n°40472116.

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The Hengshan–Wutaishan area forms part of the Trans-North-China Belt developed in response to the final amalgamation of the North China Craton. The Hengshan–Wutaishan domain and the adjacent Fuping massif constitute the largest and the most representative rock exposure of the belt. A structural study allows us to redefine the lithological and tectonic units that compose the architecture of the Hengshan–Wutaishan domain and to propose that the Trans-North-China Belt was built up through a polyphase tectonic evolution within the period 1900–1800 Ma. The first event (D1) corresponds to the emplacement of lower and upper nappes herein called the Orthogneiss and Volcanites Unit (OVU) and the Low Grade Mafic Unit (LGMU), respectively. The OVU mainly consists of rocks formed in an arc system and metamorphosed under amphibolite facies conditions whereas the LGMU represents oceanic crust rocks with an arc component that underwent greenschist facies metamorphism. The syn-metamorphic D1 deformation is characterized by a NW–SE stretching and mineral lineation with a top-to-the SE sense of shear that corresponds to the sense of nappe motion. U–Th–Pb EPM chemical dating on monazite from three metapelites of the OVU gives isochron ages of 1884 ± 11 Ma, 1886 ± 5 Ma and 1887 ± 4 Ma interpreted as the age of the prograde amphibolite facies metamorphism coeval with nappe stacking during the D1 event. The D2 event corresponds to a widespread crustal melting of the OVU and underlying basement rocks in Hengshan related to the exhumation of deep structures about 20–30 Ma after nappe emplacement. The migmatite contains blocks of retrograded eclogite or HP-granulitic restites, and is characterized by the development of a pervasive foliation and lineation. A late D2 event represents the folding stage of the migmatitic foliation during the completion of a dome. The Orthogneiss and Volcanics Unit and the Low Grade Mafic Unit are unconformably covered by weakly metamorphosed to unmetamorphosed sediments belonging to the Hutuo Supergroup. These rocks were deformed by a ductile D3 event, characterized by a NW–SE trending stretching lineation, south verging folds associated with an axial planar slaty cleavage and an E–W crenulation lineation. Lastly, a left-lateral wrenching along the Zhujiafang Shear Zone separates the northern and southern parts of Hengshan. Our structural study shows that there is no significant difference between the southern part of Hengshan and the lower part of Wutaishan, both areas belong to OVU and show a structural continuity. We suggest that this polyphase deformation developed in response to a north-westward subduction of an old ocean, named the Lüliang Ocean, beneath the Western Block, followed by collision with a micro-continent named the Fuping Block at not, vert, similar1890–1880 Ma.
ISSN: 0301-9268

insu-00151594
https://hal-insu.archives-ouvertes.fr/insu-00151594
https://hal-insu.archives-ouvertes.fr/insu-00151594/document
https://hal-insu.archives-ouvertes.fr/insu-00151594/file/Trap-PrecambrainResearch-2007.pdf
DOI : 10.1016/j.precamres.2007.03.001

| Plus

Nos Antilles : Trois siècles de vie française
Auteur(s) : Denis, Serge (1...-1955)
Auteurs secondaires : Gallouédec, Louis (1864-1937)
Année de publication :

| Plus

Formation of conical fractures in sedimentary basins: Experiments involving pore fluids and implications for sandstone intrusion mechanisms
Auteur(s) : Mourgues, R. Bureau, D. Bodet, Ludovic GAY, Aurélien Gressier, J. B.
Auteurs secondaires : Laboratoire de Planétologie et Géodynamique de Nantes (LPGN) ; Université de Nantes (UN) - Institut national des sciences de l'Univers (INSU - CNRS) - Centre National de la Recherche Scientifique (CNRS) Structure et fonctionnement des systèmes hydriques continentaux (SISYPHE) ; Université Pierre et Marie Curie - Paris 6 (UPMC) - École pratique des hautes études (EPHE) - MINES ParisTech - École nationale supérieure des mines de Paris - Centre National de la Recherche Scientifique (CNRS) Géosciences Montpellier ; Université des Antilles et de la Guyane (UAG) - Institut national des sciences de l'Univers (INSU - CNRS) - Université de Montpellier (UM) - Centre National de la Recherche Scientifique (CNRS)

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Large sand intrusions often exhibit conical morphologies analogous to magmatic intrusions such as saucer-shaped or cup-shaped sills. Whereas some physical processes may be similar, we show with scaled experiments that the formation of conical sand intrusions may be favoured by the pore-pressure gradients prevailing in the host rock before sand injection. Our experiments involve injecting air into a permeable and cohesive analogue material to produce hydraulic fractures while controlling the pore pressure field. We control the state of overpressure in the overburden by applying homogeneous basal pore pressure, and then adding a second local pore pressure field by injecting air via a central injector to initiate hydraulic fractures near the injection point. In experiments involving small vertical effective stresses (small overburden, or high pore fluid overpressure), the fracturing pressure (lambda(fract)) is supralithostatic and two dipping fractures are initiated at the injection point forming a conical structure. From theoretical considerations, we predict that high values of lambda(fract), are due to strong cohesion or high pore fluid overpressure distributed in the overburden. Such conditions are favoured by the pore pressure/stress coupling induced by both pore pressure fields. The dips of cones can be accounted for elastic-stress rotation occurring around the source. Contrary to magmatic chamber models, the aqueous fluid overpressure developed in a parent sandbody (and prevailing before the formation of injectites) may diffuse into the surrounding overburden, thus favouring stress rotation and the formation of inclined sheets far from the parent source. For experiments involving higher vertical effective stresses (thick overburden or low pore fluid overpressure), the fracturing pressure is lower than the lithostatic stress, and a single fracture is opened in mode I which then grows vertically. At a critical depth, the fracture separates into two dilatant branches forming a flat cone. We make use of a P.I.V. (Particle Imaging Velocimetiy) technique to analyse plastic deformation, showing that these inclined fractures are opened in mixed modes. Close to the surface, they change into steep shear bands where fluids can infiltrate. The final morphology of the fracture network is very similar to the common tripartite architecture of various injection complexes, indicating that different mechanisms may be involved in the formation of dykes. Feeder dykes under the sill zones may open as tensile fractures, while overlying dykes may be guided by the deformation induced by the growth of sills. These deformation conditions may also favour the formation of fluid escape structures and pockmarks. (C) 2011 Elsevier B.V. All rights reserved.
ISSN: 0012-821X

hal-00745640
https://hal.archives-ouvertes.fr/hal-00745640
DOI : 10.1016/j.epsl.2011.10.029

| Plus