Éditeur(s) : HAL CCSD De Gruyter
Résumé : International audience
This study aims at better understanding the respective influences of specific gravity (γ), microfibril angle (MFA), and cell-wall matrix polymers on viscoelastic vibrational properties of wood in axial direction. The wide variations of properties between normal wood (NW) and compression wood (CW) are in focus. Three young bent trees (Picea abies, Pinus sylvestris and Pinus pinaster) that recovered verticality were sampled. Several observed differences between NW and CW were highly significant in terms of anatomical, physical (γ, shrinkage, CIELab colorimetry), mechanical (compressive strength), and vibrational properties. Specific dynamic modulus of elasticity (E'/γ) decreases with increasing MFA, and Young's modulus (E') can be satisfactorily explained by γ and MFA. Apparently, the type of the cell wall polymer matrix is not influential in this regard. The damping coefficient (tanδ) does not depend solely on MFA of NW and CW. The tanδ - E'/γ relationship evidences that, at equivalent E'/γ, the tanδ of CW is approx. 34% lower than that of NW. This observation is ascribed to the more condensed nature of CW lignins, and this is discussed in the context of previous findings in other hygrothermal and time/frequency domains. It is proposed that the lignin structure and the amount and type of extractives, which are both different in various species, are partly responsible for taxonomy-related damping characteristics.
ISSN: 0018-3830

hal-00808062
https://hal.archives-ouvertes.fr/hal-00808062
https://hal.archives-ouvertes.fr/hal-00808062/document
https://hal.archives-ouvertes.fr/hal-00808062/file/Changes_viscoelastic_vibrational_Bremaud_al.pdf
DOI : 10.1515/hf-2011-0186

Éditeur(s) : HAL CCSD
Résumé : The presence of biological matter (biofilms) in deep geological sites for storage of, for instance, toxic elements or groundwater in aquifers was clearly proved. That biomass triggers physical and chemical processes which greatly modify the durability and the sustainability of the sites. These processes, mainly from oxidative/reductive reactions, are poorly understood. This is mainly due to the fact that former studies were done at the macroscopic level far away from the micrometric scale where relevant processes induced by bacteria take place. Investigations at microscopic level are needed. Thus, we developed an experimental set-up based on the combined use of optical microscopy (transmission), atomic force microscopy (AFM) and electrical and electro-chemical AFM microscopy (EC_AFM) in order to get simultaneous information on topographic and electro-chemical processes. The first highly sensitive step was to use AFM with biological samples in liquid environment: wepresent here a study about AFM imaging of living, moving or self-immobilized bacteria, in their genuine physiological liquid medium and in true in vivo conditions. No external immobilization protocol, neither chemical nor mechanical was needed. For the first time, the native gliding movements of Gram negative Nostoc cyanobacteria upon the surface were studied by AFM. AFM height and mechanical stiffness data were simultaneously acquired. From these, mechanical parameters, inner turgor pressure and Young modulus, were derived for different bacterial species (Anabaenopsis circularis, Rhodococcus wratislaviensis). Our study revealed that AFM imaging is thus possible on moving living species. These results open a large window on new studies of both dynamical phenomena of practical and fundamental interests such as the formation of biofilms and dynamic properties of bacteria in real physiological conditions. The second delicate step was to combine AFM and optical measurements with electrical ones. We mounted a new experimental set-up coupling real-time (i) monitoring of optical properties as the optical density (OD) evolution related to bulk bacterial growth in liquid or as the counting of number of bacteria adhering on the surface of the sample as well and (ii) electrical and electrochemical measurements. Furthermore, these results will shortly be applied to the optimized monitoring of the in-situ activity of bacteria consuming oil pollutants, following this way, in real-time, the bioremediation of an oilcontaminated soil (ANR ECOTECH_BIOPHY program).
La présence de matière biologique (biofilms) dans les sites de stockage géologique profond, d'éléments toxiques ou encore de l'eau potable des aquifères est maintenant clairement démontrée. Cette biomasse est à l'origine de processus physiques et chimiques qui modifient considérablement la durabilité et la pérennité des sites concernés. Ces processus, principalement de type oxydo-réductif, sont encore mal compris. Ceci est principalement dû aux méthodes d'investigation, principalement macroscopiques, loin de l'échelle micrométrique caractéristique des bactéries. Seules des études, basées sur des méthodes d'investigation locale, peuvent apporter les informations requises. Ainsi, nous avons développé un dispositif expérimental basé sur l'utilisation combinée de la microscopie optique (en transmission), la microscopie à force atomique (AFM) et la microscopie AFM en mode électrique et électrochimique (EC_AFM) afin d'obtenir des informations simultanées sur la topographie de l'échantillon et sur les processus électrochimiques à l'échelle des bactéries. La première étape sensible consistait à utiliser l'AFM sur des échantillons biologiques en milieu liquide: nous présentons ici les résultats de l'imagerie AFM en milieu liquide de plusieurs types de bactéries dans leurs conditions physiologiques naturelles (conditions in vivo). Aucun protocole d'immobilisation, ni chimique ni mécanique, n'a été nécessaire; et pour la première fois, les mouvements de reptation de cyanobactéries Nostoc ont été étudiés par l'AFM. Les études AFM ont permis d'acquérir des données topographiques mais aussi mécaniques : nous avons pu ainsi mesurer le module d'Young, la pression de turgescence de différentes souches bactériennes (Anabaenopsis circularis, Rhodococcus wratislaviensis). Cette étude complète, a révélé que l'imagerie AFM est donc possible sur des espèces vivantes en mouvement. Ces résultats ouvrent une grande fenêtre sur de nouvelles études d'intérêts tels que la formation de biofilms et les propriétés dynamiques de bactéries dans des conditions physiologiques réelles. La deuxième étape délicate était de combiner l'AFM aux mesures optiques et électriques. Nous avons développé un nouveau dispositif expérimental permettant (i) le suivi de l'évolution de la croissance bactérienne par la mesure des propriétés optiques comme la densité optique DO (pour le développement bactérien en volume - milieu planctonique) , ou l'analyse de l'image du substrat par comptage du nombre de bactéries sur la surface de l'échantillon (biofilm), et (ii) les mesures électriques et électrochimiques. L'ensemble de ces résultats sera prochainement appliqué au développement de nouveaux outils de surveillance d'une biodépollution de terrain contaminé par les hydrocarbures, par le suivi in situ et en temps réel de l'activité de bactéries dépolluantes (ECOTECH_BIOPHY ANR).
https://tel.archives-ouvertes.fr/tel-01044714

tel-01044714
https://tel.archives-ouvertes.fr/tel-01044714
https://tel.archives-ouvertes.fr/tel-01044714/document
https://tel.archives-ouvertes.fr/tel-01044714/file/theseDhahri2013.pdf

Éditeur(s) : HAL CCSD Springer Verlag (Germany)
Résumé : International audience
*Context Increased knowledge on diversity in wood properties would have implications both for fundamental research and for promoting a diversification of uses as material. *Aims The objective is to contribute to overcoming the critical lack of data on the diversity of wood dynamic mechanical/viscoelastic vibrational properties, by testing lesser-known species and categorizing sources of variability. *Methods Air-dry axial specific dynamic modulus of elasticity (E'/γ) and damping coefficient (tanδ) were measured on a wide sampling (1792 specimens) of 98 wood types from 79 species. An experimental device and protocol was designed for conducting systematic (i.e. rapid and reproducible) characterizations. *Results Diversity at the specimens' level corroborates the "standard" relationship between tanδ and E'/γ, which is discussed in terms of orientation of wood elements and of chemical composition. Diversity at the species level is expressed on the basis of results for normal heartwood, with specific gravity (γ) ranging from 0.2 to 1.3. Axial E'/γ ranges from 9 to 32 GPa and tanδ from 4×10-3 to 19×10-3. Properties distribution follows a continuum, but with group characteristics. The lowest values of tanδ are only found in certain tropical hardwoods. Results can also suggest alternative species for musical instruments making.
Annals of Forest Science

hal-00808242
https://hal.archives-ouvertes.fr/hal-00808242
https://hal.archives-ouvertes.fr/hal-00808242/document
DOI : 10.1007/s13595-011-0166-z

Éditeur(s) : HAL CCSD Springer Verlag
Résumé : International audience
Radial trends of vibrational properties, including the specific dynamic modulus (E'/r) and damping coefficient (tand), were investigated for 3 tropical rainforest hardwood species, Simarouba amara, Carapa procera and Symphonia globulifera by free-free flexural vibration test. The microfibril angle (MFA) was estimated through X-Ray diffraction. Consistent patterns of radial variations were observed for all studied properties. E'/r was found to decrease from pith to bark, which is strongly related to the increasing pith-bark trend of MFA. The variation of tand along the radius can be partly explained by MFA, and partly by the gradient of extractives due to heartwood formation. The coupling effect of MFA and extractives could be separated through the analysis of log(tand) - log(E'/r) diagram. For the studied species, the extractive content putatively associated to heartwood formation generally tends to decrease the wood damping coefficient. However, this weakening effect of extractives was not observed for inner part of the heartwood, suggesting the mechanical action of extractives was reduced during their chemical ageing.
ISSN: 1435-0211

hal-00797055
https://hal.archives-ouvertes.fr/hal-00797055
https://hal.archives-ouvertes.fr/hal-00797055/document
https://hal.archives-ouvertes.fr/hal-00797055/file/Radial_variations_vibrational_Zhang_al.pdf

Éditeur(s) : HAL CCSD Springer Verlag/EDP Sciences
Résumé : International audience
Context and aim : This study aimed to examine the effect of the tension wood G‐layer on the viscoelastic properties of wood. Methods : Tension wood and opposite wood samples were obtained from six French Guianese tropical rainforest species (Sextonia rubra, Ocotea guyanensis, Inga alba, Tachigali melinoni, Iyranthera sagotiana and Virola michelii); the tension wood of the former three of these species had a Glayer, whilst the tension wood from the latter three had no Glayer. Tensile dynamic mechanical analysis (DMA) was performed on green never dried wood samples in the longitudinal direction with samples submerged in a water bath at a temperature (30°C) and frequency (1 Hz) representative of the conditions experienced by wood within a living tree. Then, DMA was repeated with samples conditioned to an air-dried state. Finally, samples were oven-dried to measure longitudinal shrinkage. Results : Tension wood did not always have a higher longitudinal storage (elastic) modulus than opposite wood from the same tree regardless of the presence or absence of a G‐layer. For the species containing a G‐layer, tension wood had a higher damping coefficient and experienced a greater longitudinal shrinkage upon drying than opposite wood from the same species. No difference was found in damping coefficients between tension wood and opposite wood for the species that had no G‐layer. Conclusion : It is proposed that the different molecular composition of the G-layer matrix has an influence on the viscoelasticity of wood, even if a biomechanical gain is not yet clear. This study shows that rheological properties and longitudinal shrinkage can be used to detect the presence of a G‐layer in tension wood.
ISSN: 1286-4560

hal-00677460
https://hal.archives-ouvertes.fr/hal-00677460
https://hal.archives-ouvertes.fr/hal-00677460/document
https://hal.archives-ouvertes.fr/hal-00677460/file/Clair2.pdf
DOI : 10.1007/s13595-011-0164-1

Éditeur(s) : HAL CCSD Springer Verlag/EDP Sciences
Résumé : International audience
Background : This study examines the radial trend in wood stiffness of tropical rainforest trees. The objective was to determine if the type of growing environment (exposed plantation or dense primary forest) would have an effect on this radial trend. Methods : The axial elastic modulus of wood samples, representing a pith to bark cross-section, of six trees from several French Guianese species (two of Eperua falcata, one of Eperua grandiflora, two of Carapa procera and one of Symphonia gloubulifera) was measured using a dynamic "forced vibration" method. Results : Primary forest trees were observed to have a decrease in wood stiffness from pith to bark, whereas plantation trees, from the same genus or species, displayed a corresponding increase in wood stiffness. Juvenile wood stiffness appears to vary depending on the environment in which the tree had grown. Conclusion : We suggest that the growth strategy of primary forest trees is to produce wood resistant to selfbuckling so that the height of the canopy may be obtained with the maximum of efficiency. In contrast, the growth strategy of the trees growing in an exposed plantation is to produce low-stiffness wood, important to provide flexibility in wind. Further experiments to study the behaviour of more species, with more individuals per species, growing across a range of physical environments, are required.
ISSN: 1286-4560

hal-00644335
https://hal.archives-ouvertes.fr/hal-00644335
https://hal.archives-ouvertes.fr/hal-00644335/document
https://hal.archives-ouvertes.fr/hal-00644335/file/McLean_al.pdf
DOI : 10.1007/s13595-011-0085-z