Éditeur(s) : HAL CCSD
Résumé : International audience
International Journal of GreenhouseGas Control

hal-01314405
https://hal-brgm.archives-ouvertes.fr/hal-01314405

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We use a strike-slip fault analog model to study experimentally the role played by along-fault non-uniform and asymmetric applied normal stress on both coseismic slip and long-term fault behavior. Our model is based on a visco-elasto-plastic multi-layered rheology that allows to produce several hundreds of scaled analog microquakes and associated seismic cycles. Uniform or heterogeneous applied normal stress along the fault plane is imposed and maintained constant during the whole experiment durations. Our results suggest that coseismic slip patterns are strongly controlled by spatial normal stress variations and subsequent accumulated shear stress along fault strike. Major microquakes occur preferentially in zones of major shear stress asperities. Coseismic slip distributions exhibit a pattern similar to the along-fault applied normal stress distribution. The occurrence of isolated low to moderate microquakes where residual stresses persist around secondary stress asperities, indicates that stress conditions along the fault also control the whole variability of fault slip events. Moreover, when fault slip stability conditions are modulated by normal stress distribution, our experiments suggest that the along-fault stress heterogeneity influences the seismic cycle regularity and, consequently, long-term fault slip behavior. Uniform applied normal stress favors irregular seismic cycles and the occurrence of earthquakes clustering, whereas non-uniform normal stress with a single high amplitude stress asperity generates strong characteristic microquake events with stable return periods. Together our results strengthen the assumption that coseismic slip distribution and earthquake variability along an active fault may provide relevant information on long term tectonic stress and could thus improve seismic hazard assessment.
ISSN: 0012-821X

hal-01666379
https://hal.archives-ouvertes.fr/hal-01666379
DOI : 10.1016/j.epsl.2017.10.009

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
A shallow field experimental site for CO2 injection was established at Maguelone (Languedoc, France), in order to test in an integrated manner a suite of surface and downhole hydrogeophysical monitoring methods. The objective is to improve monitoring of gas transport in the shallow subsurface and to determine the sensitivity of CO2 monitoring systems for leakage detection. The site offers a natural laboratory to study the processes associated with CO2 injection in a clastic and clay-rich context saturated with saline fluids. Prior to CO2 injection, three nitrogen (N2) injections were undertaken in 2012 to measure the site response to neutral gas injection. In 2013, a volume of 111 m3 (mass of 220 kg) of CO2 was injected during 3.5 h at 15 m depth. During each experiment, the gas plumes were successfully detected from pressure monitoring, time-lapse induction logging and downhole resistivity monitoring with dipole–dipole array. Increases in resistivity are attributed to free gas propagation (either N2 or CO2) whereas decreases in resistivity correlate with CO2 dissolution in the pore fluid. Chemical analyses confirm this hypothesis with a decrease in pH and an increase in the concentration of dissolved species in the latter case.
ISSN: 1750-5836

hal-01355943
https://hal.archives-ouvertes.fr/hal-01355943
DOI : 10.1016/j.ijggc.2015.12.005

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
We review the evolution of concepts on and methods of estimating the state of stress from fault movements. Theories of failure in isotropic materials suggested a simple geometrical construction of optimal principal stress directions from a fault plane and its associated slip. These optimal directions align shear stress and slip directions and maximize the difference between shear stress and frictional resistance on the fault plane. Optimal stress directions for calcite twinning are obtained by a similar construction, with the difference that they maximize shear stress. Force representation of seismic sources independently introduced pressure, P, and tension, T, axes at positions that also maximize shear stress on both nodal planes. Frictional slip theory and the constraint that slip and shear stress directions be parallel allowed to address reactivation of pre-existing faults. This suggested that stress could also be inverted from reactivated fault and slip data or earthquake focal mechanisms. Early methods relied on geometrical constructions as a substitute for calculations, whereas later methods relied on software as these calculations became tractable with the help of computers. Similar methods were developed for the inversion of stress from crystal twin gliding with non-optimal geometry, with a different criterion that relies on a threshold of the component of shear stress along the gliding line. Even though these methods seek a common stress tensor compatible with fault and slip data, their main use is to separate polyphase data into homogeneous subsets and help deciphering complex tectonic histories. Fault and slip data can also be analyzed to constrain the strain rather than the stress tensor. In most cases this involves a summation and yields an average strain for the considered rock volume. Stress inversion thus appears better suited for differentiating heterogeneous data whereas strain analysis appears better suited for homogenizing them.
ISSN: 0040-1951

hal-00759043
https://hal.archives-ouvertes.fr/hal-00759043
DOI : 10.1016/j.tecto.2012.02.009

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Wallace (1951) and Bott (1959) were the first to introduce the idea that the slip on each fault surface has the same direction and sense as the maximum shear stress resolved on that surface. However, this simplified hypothesis is questionable since fault mechanical interactions may induce slip reorientations. Earlier numerical geomechanical models confirmed that the slickenlines (slip vectors) are not necessarily parallel to the maximum resolved shear stress but are consistent with local stress perturbations. This leads us to ask as to what extent the Wallace and Bott simplifications are reliable as a basis hypothesis for stress inversion from fault slip data. Here, a geomechanical multi-parametric study using a 3D boundary element method, covering (i) fault geometries such as intersected faults or corrugated fault surfaces, (ii) the full range of Andersonian state of stress, (iii) fault friction, (iv) fault fluid pressure, (v) half space effect and (vi), rock properties, is performed in order to understand the effect of each parameter on the misfit angle between geomechanical slip vectors and the resolved shear stresses. It is shown that significant misfit angles can be found under specific configurations invalidating the Wallace and Bott assumptions, even though fault friction tends to minimize the misfit. We therefore conclude that in such cases, stress inversions based on fault slip data should be interpreted with care.
ISSN: 0040-1951

hal-01218418
https://hal.archives-ouvertes.fr/hal-01218418
DOI : 10.1016/j.tecto.2015.06.030

Éditeur(s) : HAL CCSD
Résumé : International audience
A CO 2 migration field laboratory for testing of monitoring methods has been established in the glaciofluvial-glaciomarine Holocene deposits of the Svelvik ridge, near Oslo. A shallow CO 2 injection experiment was conducted in September 2011 in which approximately 1700 kg of CO 2 was injected at 18 m depth below surface. The objectives of this experiment were to (i) detect and, where possible, quantify migrated CO 2 concentrations, (ii) evaluate the sensitivity of the monitoring tools and (iii) study the impact of the vadose zone on measurements. This paper describes the injection, discusses the joint interpretation of the results and suggests some recommendations for further work.
The 7th Trondheim CCS Conference
Trondheim, Norway

hal-01314396
https://hal-brgm.archives-ouvertes.fr/hal-01314396
https://hal-brgm.archives-ouvertes.fr/hal-01314396/document
https://hal-brgm.archives-ouvertes.fr/hal-01314396/file/1-s2.0-S1876610214008704-main.pdf
DOI : 10.1016/j.egypro.2014.07.008

Éditeur(s) : HAL CCSD Wiley
Résumé : International audience
Most of the Mediterranean coastal porous aquifers are intensively exploited. Because of climatic and anthropogenic effects, understanding the physical and geological controls on groundwater distribution and flow dynamics in such aquifers is crucial. This study presents the results of a structural investigation of a system located along the coastline of the Gulf of Lions (NW Mediterranean). A key aspect of this study relies on an onshore-offshore integrated approach combining outcrops, seismic profiles, and borehole data analysis. This multidisciplinary approach provides constraints on pore-fluid salinity distribution and stratigraphic organization, which are crucial in assessing the modes of groundwater/seawater exchanges. Onshore, Lower Pliocene deposits dip gently seaward. They are unconformably overlain by Holocene clays in the lagoons. Offshore the Pliocene deposits either outcrop at the seabed or are buried below nonconsolidated sands infilling paleo-valleys. Beneath the lido, the groundwater salinity distribution consists of salty pore water, overlying fresher pore water. Active circulation of groundwater masses is inferred from the geophysical results. In particular, offshore outcrops and paleo-valleys may play an important role in salt water intrusion.
ISSN: 0017-467X

halsde-00866825
https://hal.archives-ouvertes.fr/halsde-00866825
DOI : 10.1111/j.1745-6584.2012.01011.x