Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
The present study aims to apply the AMS method (Anisotropy of Magnetic Susceptibility) at a regional scale to track the fluid circulation direction that has produced an iron metasomatism within pre-existing dolomite host rock. The Urgonian formations hosting the Zn-Pb mineralizations in La Florida (Cantabria, northern Spain) have been taken as target for this purpose. Sampling was carried out, in addition to ferroan dolomite host rock enclosing the Zn-Pb mineralizations, in dolomite host rock and limestone to make the comparison possible between magnetic signals from mineralized rocks, where fluid circulation occurred, and their surrounding formations. AMS study was coupled with petrofabric analysis carried out by texture goniometry, Scanning Electron Microscopy (SEM) observations and also Shape Preferred Orientation (SPO) statistics. SEM observations of ferroan dolomite host rock illustrate both bright and dark grey ribbons corresponding respectively to Fe enriched and pure dolomites. SPO statistics applied on four images from ferroan dolomite host rock give a well defined orientation of ribbons related to the intermediate axis of magnetic susceptibility K2. For AMS data, two magnetic fabrics are observed. The first one is observed in ferroan dolomite host rock and characterised by a prolate ellipsoid of magnetic susceptibility with a vertical magnetic lineation. The magnetic susceptibility carrier is Fe-rich dolomite. These features are probably acquired during metasomatic fluid circulations. In Fe-rich dolomite host rock, ‹c› axes are vertical. As a rule, (0001) planes (i.e. planes perpendicular to ‹c› axes) are isotropic with respect to crystallographic properties. So, the magnetic anisotropy measured in this plane should reflect crystallographic modification due to fluid circulation. This is confirmed by the texture observed using the SEM. Consequently, AMS results show a dominant NE-SW elongation interpreted as the global circulation direction and a NW-SE secondary elongation that we have considered as sinuosities of the fluid trajectory. The second type of magnetic fabric is essentially observed in the limestone and characterised by an oblate form of the ellipsoid of magnetic susceptibility, a horizontal magnetic foliation and mixed magnetic susceptibility carriers. It is interpreted as a sedimentary fabric.
ISSN: 0012-821X

insu-00342499
https://hal-insu.archives-ouvertes.fr/insu-00342499
https://hal-insu.archives-ouvertes.fr/insu-00342499/document
https://hal-insu.archives-ouvertes.fr/insu-00342499/file/Essalhi-EPSL-2008.pdf
DOI : 10.1016/j.epsl.2008.11.011

Éditeur(s) : HAL CCSD Elsevier
Résumé : We have studied the phase transformation of forsterite to wadsleyite under shear stress at the Earth's transition zone pressure and temperature conditions. Two-step experiments were performed using a multi-anvil press. First, we hot pressed iron-free forsterite at 6 or 11 GPa and 1100 degrees C. Then we deformed a slab of this starting material using a direct simple shear assembly at 16 GPa and 1400 degrees C for 1, 15, 35, 40, or 60 min. Both the starting material and the deformed samples were characterized using optical and scanning electron microscopy including measurements of crystal preferred orientations (CPO) by electron back scattered diffraction (EBSD), transmission electron microscopy (TEM), and Fourier transform infrared spectroscopy (FTIR). The phase transformation occurs very rapidly, in less than 1 min, and metastable forsterite relics are not observed after deformation. The grain size of wadsleyite is slightly smaller than the forsterite starting material. The water contents obtained from FTIR analyses in forsterite and wadsleyite are 65-124 wt ppm H2O and 114-736 wt ppm H2O, respectively, which are well below water solubility at similar conditions in the presence of free water. Wadsleyite aggregates display weak CPO patterns with [1 0 0] axes concentrated at low angle to the shear direction, [0 1 0] axes perpendicular to the shear plane and nearly random [0 0 1] axes. Only a few dislocations were observed in wadsleyite with TEM. This observation is consistent with the assumption that most dislocations formed during the initial high-stress stages of these stress-relaxation experiments, were consumed in the phase transformation, probably enhancing the transformation rate. CPO patterns vary as a function of the water content: with increasing water content the density of [1 0 0] axes parallel to the shear direction decreases, and the density of [0 0 1] axes increases. Viscoplastic self-consistent modeling of CPO evolution using previously reported glide systems for wadsleyite, i.e., [1 0 0]{0 k 1} and 1/2 (1 1 1){1 0 1}, cannot reproduce the measured CPO, unless the [0 0 1](0 1 0) system, for which dislocations have not been observed by TEM, is also activated. In addition, wadsleyite grain growth suggests the participation of diffusion-assisted processes in deformation. Calculated anisotropies for P and S-waves using measured CPO are always below 1%. This very low anisotropy is due to both the low finite strain achieved in the experiments, which leads to weak wadsleyite CPO, and to the diluting effect of added majorite. The present experiments emphasize the importance of stress, grain size evolution and water content in the forsterite to wadsleyite phase transformation and subsequent deformation in the transition zone.
ISSN: 0031-9201

hal-00617430
https://hal.archives-ouvertes.fr/hal-00617430
DOI : 10.1016/j.pepi.2010.11.001

Éditeur(s) : HAL CCSD Mineralogical Society of America
Résumé : International audience
In situ mineralization of CO2 in ultramafic rock-hosted aquifers is one of the promising solutions for decreasing CO2 concentrations in the atmosphere. Naturally altered ultramafic rocks suggest that carbonation processes are controlled by local heterogeneities in the structure of the rock and fluid transport at the water-rock interfaces. We studied the role of rock crystallographic anisotropy relative to the global fluid flow direction on the mineralization of CO2 by means of electron microscope analyses from the macro- to the micrometer scale (EBSD-FIB). The sample used for the measurements was a hot pressed olivine core percolated by water enriched in CO2 (pCO2 = 10 MPa) at 180 °C. During the percolation experiment, olivine was dissolved and two types of carbonates, dolomite, and magnesite, were precipitated on olivine surfaces. The results showed that the dissolution of olivine is controlled by its crystallographic properties as shown by the development of etch-pits only on the (010)ol planes and with elongated shapes parallel to the [010]ol axes. In contrast, the precipitation of carbonates is governed by hydrodynamic properties. Carbonates are heterogeneously distributed in the percolated rock. They are mainly located along the moderate (for dolomite) and the minor (for magnesite) flow paths, both oriented parallel to the principal fluid flow direction, which allow carbonates to be supplied with divalent cations (e.g., Ca2+, Mg2+, and Fe2+). In these flow paths, carbonate growth is systematically oriented normal to the flow that facilitates the development of chemical gradients with cationic supersaturation conditions for carbonate precipitation near the walls.In natural systems, the (010)ol planes are parallel to the Moho and the (100)ol planes are vertical; our study suggests that flow of CO2-rich fluids will induce precipitation of carbonates localized along, and preferentially clogging, vertical flow paths while favoring olivine dissolution along horizontal fluid pathways. This dual control of structure and fluid flow on carbonation mechanisms could be an important parameter allowing sustainable CO2 storage in peridotites, while limiting the risks of leakage toward the surface.
ISSN: 0003-004X

hal-01143393
https://hal.archives-ouvertes.fr/hal-01143393
DOI : 10.2138/am-2015-4913

Éditeur(s) : HAL CCSD Elsevier
Résumé : Spinel peridotite xenoliths from Persani Mountains, Southeastern Carpathians, Romania, were submitted to deformation by dislocation creep accompanied by dynamic recrystallization under variable stress and temperature conditions. Predominance of low-angle boundaries parallel to (100) with well-defined [Ovw] rotation axes in olivine indicates that subgrain rotation is the main recrystallization mechanism and that dislocation glide occurs mainly in [100]{0k1} systems. Analysis of olivine crystal preferred orientations highlights that recrystallization results in dispersion of the orientations of recrystallized grains relatively to the parent grains. This dispersion may be quantified by a dimension-less dispersion factor defined as the ratio of the random component of the [100] axis distributions between the recrystallized grains and porphyroclasts. This factor is largely independent from the overall fabric strength, the number of grains analyzed, and the recrystallized grain size. The olivine CPO strength and anisotropy at the rock scale, quantified by J-index, are largely controlled by the volume of recrystallized grains, which depends on finite strain. Comparison of olivine CPO in coarse- and fine-grained porphyroclastic peridotites shows that deviatoric stress and temperature conditions play nevertheless a role on the CPO evolution during recrystallization; selective grain growth, which is favored at high temperature and low stresses, does counteract the dispersion produced by the nucleation processes.
ISSN: 0191-8141

hal-00669963
https://hal.archives-ouvertes.fr/hal-00669963
DOI : 10.1016/j.jsg.2011.09.010

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Several studies, both theoretical and experimental, show that sedimentary rocks have fractal pore-grain interface. The real rocks are 3-d structures with highly tortuous and often fractal pore spaces. Before attempting simulation of this daunting geometry, we present here, as a preliminary study, a simpler 2-d version. In this paper, a computer simulated 2-d sedimentary rock structure is generated by the relaxed bidisperse ballistic deposition model. Grains of two different sizes are dropped ballistically on a linear substrate. By changing the fraction of the two types of particles, the porosity of the rock structure can be tuned. The structure undergoes compaction through the relaxation of possible unstable overhangs. The micro structure of the pore space is investigated. The pore mass and the rock-pore interface show a fractal behaviour with the same fractal dimension indicating that the pore volume is a fractal. Our simulation results indicate that the process of compaction of grains during the deposition process seems to erase the dependency of the fractal dimension on the grain size distribution. The two point density correlation is measured for the pore space. It shows anisotropy which is an outcome of the growth rule. X-ray tomography of two-dimensional sections of real sedimentary rocks obtained from Mallorca Island is subjected to the same study and the results compared with those obtained from simulation. The simulation results agree qualitatively with the real rock sample. We also study diffusion on the pore space. Diffusion is found to be anomalous as is expected in fractal spaces. It also bears the signature of anisotropy of the structure. Diffusion studies on the real rock sample could not yield conclusive results as the system size is not large enough.
ISSN: 0926-9851

hal-00761818
https://hal.archives-ouvertes.fr/hal-00761818
DOI : 10.1016/j.jappgeo.2012.09.002

Éditeur(s) : HAL CCSD Walter de Gruyter
Résumé : absent
Holzforschung

hal-01031939
https://hal.archives-ouvertes.fr/hal-01031939
DOI : 10.1515/HF.2005.057