Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
The outstanding exposure of deformation bands in a multilayer sequence of the Orange quarry, Provence, France, motivates a study investigating the development and controls of deformation band geometries by field mapping combined with finite element modeling. Field mapping yields new insights into angular relations between, and evolution of, the deformation bands as well as provides input parameters for the setup and boundary conditions of the numerical simulations using ADELI 2D. In particular, reverse-sense deformation bands are found to have developed within three of the four exposed layers of the multilayer stack with similar orientations to bedding, indicating layer-parallel contraction. Numerical simulations, carried out as a parametric study to investigate the influence on deformation band development and geometry, successfully reproduce the sequential development of deformation bands in the three layers as seen in the field as well as recreate the observed angular geometries of similar to 39 degrees to the maximum compression. This angular relationship is put into context with observations from other field studies and theoretical values to explore controls of deformation band orientations. Furthermore, band localization is impeded in the model by increased layer cohesive strength, demonstrating the importance of host-rock property variations on where localization of bands within the multilayer sequence. Results from both field investigation and numerical simulations are consistent with regional tectonics, where the strata underwent gentle folding due to thrust faulting at depth, and bring further insight into the development and geometry of deformation bands in both extensional and contractional tectonic regimes.
ISSN: 0148-0227

hal-00639452
https://hal.archives-ouvertes.fr/hal-00639452
DOI : 10.1029/2011JB008365

Éditeur(s) : HAL CCSD Elsevier
Résumé : To contribute to the understanding of how opening-mode fractures (joints) form and open or close at depth in layered rocks, we present a 2D numerical study aiming to determine whether tensile stress can develop in pre-fractured elastic multilayers submitted to biaxial compressive strain conditions. First, we investigate the role of the elastic and geometrical properties of the layers on the development of tensile stress in models with five bonded layers and containing one open fracture in the central layer. Our results indicate that, in absence of elastic contrast (in Young's modulus) between the layers, no tensile stress develops in the models. However, when the fractured layer is stiffer than the two adjacent layers directly above and below, a lobe of horizontal tensile stress develops centered on the pre-existing fracture. The creation of this tensile stress is contingent upon the partial closing of the fracture. The levels of tensile stress and the thickness of the lobe of tensile stress increase logarithmically with an increase in the elastic contrast and are systematically larger for a larger Soft/Stiff ratio (ratio of the total thickness of the soft layers with the total thickness of the stiff layers). Second, we investigate the role of fracture interaction in the development of tensile stress in models containing a pair of open fractures. We observe that the levels of tensile stress in the region between the fractures are systematically higher than those observed in identical models containing a single fracture. This increase in tensile stress is very large for small elastic contrasts between the layers but diminishes when the elastic contrast increases. Furthermore, the spacing between the pre-existing fractures plays an important role in the stress distribution in the region between them. When the fracture spacing is equal to or lower than 1.15 times the height of the fractured layer for the experimental conditions chosen, the lobes of tensile stress centered on the fractures coalesce. This results in the formation of vast areas of tensile stress in models under remote compressive loading conditions. Such tensile areas are likely to allow the initiation and propagation of subsequent opening-mode fractures. The results obtained provide new insights into the formation of joints in layered rocks in compressive environments, with important consequences on fluid flow.
ISSN: 0040-1951

hal-00407576
https://hal.archives-ouvertes.fr/hal-00407576
DOI : 10.1016/j.tecto.2006.12.003

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy B - Oxford Open Option B
Résumé :  
absent
ISSN: 0829-318X

hal-01032128
https://hal.archives-ouvertes.fr/hal-01032128
DOI : 10.1093/treephys/28.10.1513

Éditeur(s) : HAL CCSD American Geophysical Union (AGU)
Résumé : International audience
Nowadays, technological advances in satellite imagery measurements as well as the development of dense geodetic and seismologic networks allow for a detailed analysis of surface deformation associated with active fault seismic cycle. However, the study of earthquake dynamics faces several limiting factors related to the difficulty to access the deep source of earthquake and to integrate the characteristic time scales of deformation processes that extend from seconds to thousands of years. To overcome part of these limitations and better constrain the role and couplings between kinematic and mechanical parameters, we have developed a new experimental approach allowing for the simulation of strike-slip fault earthquakes and analyze in detail hundreds of successive seismic cycle. Model rheology is made of multilayered visco-elasto-plastic analog materials to account for the mechanical behavior of the upper and lower crust and to allow simulating brittle/ductile coupling, postseismic deformation phase and far-field stress transfers. The kinematic evolution of the model surface is monitored using an optical system, based on subpixel spectral correlation of high-resolution digital images. First, results show that the model succeed in reproducing the deformation mechanisms and surface kinematics associated to the main phases of the seismic cycle indicating that model scaling is satisfactory. These results are comforted by using numerical algorithms to study the strain and stress distribution at the surface and at depth, along the fault plane. Our analog modeling approach appears, then, as an efficient complementary approach to investigate earthquake dynamics.
ISSN: 0278-7407

hal-01174176
https://hal.archives-ouvertes.fr/hal-01174176
DOI : 10.1002/2014TC003701

Éditeur(s) : HAL CCSD Oxford University Press (OUP): Policy B - Oxford Open Option B
Résumé :  
absent
ISSN: 0829-318X

hal-01032099
https://hal.archives-ouvertes.fr/hal-01032099
DOI : 10.1093/treephys/27.11.1505

Éditeur(s) : HAL CCSD Walter de Gruyter
Résumé : absent
Holzforschung

hal-01031939
https://hal.archives-ouvertes.fr/hal-01031939
DOI : 10.1515/HF.2005.057

Éditeur(s) : HAL CCSD Cambridge University Press (CUP)
Résumé : International audience
XFILM is a computer program for determining the thickness and composition of thin films on Substrates and multilayers by electron probe microanalysis. In this study, we describe the X-ray emission model implemented in the latest version of XFILM and assess its reliability by comparing measured and calculated k-ratios from thin-film samples available in the literature. We present and discuss examples of applications of XFILM that illustrate the capabilities of the program.
ISSN: 1431-9276

hal-00475542
https://hal.archives-ouvertes.fr/hal-00475542
DOI : 10.1017/S1431927609991218

Éditeur(s) : HAL CCSD American Geophysical Union
Résumé : International audience
Past earthquake slips on faults are commonly determined by measuring morphological offsets at current ground surface. Because those offsets might not always be well preserved, we examine whether the first 10 m below ground surface contains relevant information to complement them. We focus on the Te Marua site, New Zealand, where 11 alluvial terraces have been dextrally offset by the Wellington fault. We investigated the site using pseudo-3D Ground Penetrating Radar and also produced a high-resolution digital elevation model (DEM) of the zone to constrain the surface slip record. The GPR data reveal additional information: (1) they image the 3D stratigraphic architecture of the seven youngest terraces and show that they are strath terraces carved into graywacke bedrock. Each strath surface is overlain by 3-5 m of horizontally bedded gravel sheets, including two pronounced and traceable reflectors; (2) thanks to the multilayer architecture, terrace risers and channels are imaged at three depths and their lateral offsets can be measured three to four times, constraining respective offsets and their uncertainties more reliably; and (3) the offsets are better preserved in the subsurface than at the ground surface, likely due to subsequent erosion-deposition on the latter. From surface and subsurface data, we infer that Te Marua has recorded six cumulative offsets of 2.9, 7.6, 18, 23.2, 26, and 31 m (± 1-2 m). Large earthquakes on southern Wellington fault might produce 3-5 m of slip, slightly less than previously proposed. Pseudo-3D GPR thus provides a novel paleoseismological tool to complement and refine surface investigations
ISSN: 2169-9313

hal-00873350
https://hal.archives-ouvertes.fr/hal-00873350
DOI : 10.1002/jgrb.50317