Éditeur(s) : HAL CCSD De Gruyter
Résumé : A method for measuring shrinkage resulting from drying in the three anisotropic directions is developed and tested. Measurements are performed on sawn discs, a technique which simplifies preparation and enables large numbers of measurements. Shrinkage values can be represented as a map of the disc surface; the results indicate that comparisons between shrinkage distribution and tension wood distribution on the discs show a clear relationship and can be measured with relatively high accuracy in reference to the "shrinkage map". In the long term, this method could be useful in the timber industry as a means for choosing the direction in which logs are cut depending on their type of wood composition.
ISSN: 0018-3830

hal-00004531
https://hal.archives-ouvertes.fr/hal-00004531
https://hal.archives-ouvertes.fr/hal-00004531/document
https://hal.archives-ouvertes.fr/hal-00004531/file/Holzforschung2003_Clair-Jaouen-Beauchene-Fournier_ccsd.pdf

Éditeur(s) : HAL CCSD
Résumé : International audience
It is classically admitted that the goodfriction properties of lamellar compounds are strongly related to their anisotropic structure and especially to the existence of weak interlayer interactions through the van der Waals gap separating the basal layers. As it is also known, the presence of the van der Waals gap in the structure of lamellar compounds will allow lot of chemical species to be intercalated in the structure leading both to the expansion of structure parameters and inter layer interactions modifications. The present work is concerned with the experimental and theoretical study of friction propertiesof Graphite Intercalated Compounds (GICs) in order to better understand thetribologiclamellar compounds. In order to modulate the interlayer interactions, two types of intercalated species were used, electrophylic species (AlCl3, FeCl3, SbCl5) and nucleophilic species (Li, K, Rb).
40th Leeds-Lyon Symposium on Tribology & Tribochemistry Forum 2013
Lyon, France

Droits : info:eu-repo/semantics/OpenAccess
hal-00926509
https://hal.archives-ouvertes.fr/hal-00926509
https://hal.archives-ouvertes.fr/hal-00926509/document
https://hal.archives-ouvertes.fr/hal-00926509/file/Delbe_9781.pdf
OATAO : 9781

Éditeur(s) : HAL CCSD
Résumé : International audience
Debris avalanches derived from the flanks of volcanic islands are among the largest on Earth. Debris avalanches are rare, catastrophic destabilizations that still keep geologists debating about the mechanisms that initiate them and make them travel huge runout distances. To shed light on the trigger of such destabilizations, we studied the inland scar of a debris avalanche deposit cropping out at Piton des Neiges, a dormant and eroded basaltic volcano of La Réunion Island. The avalanche deposit rests on a pile of 50-70 sill intrusions with a shallow northward dip, i.e. toward the sea. We measured the anisotropy of magnetic susceptibility in a transect across the uppermost sill of the pile in contact with the avalanche deposit. This transect reveals a strongly asymmetric magnetic fabric, consistent with a north-directed shear movement of the upper intrusion wall. This suggests that the upper sill induced a co-intrusive shear displacement of the volcano flank toward the sea. The upper sill margin in contact with the avalanche is striated, showing that this intrusion is older than the avalanche. Striae indicate a northward direction of avalanche runout. The upper sill margin also displays a magmatic lineation consistent with a magma flow in the intrusion toward the north. There is thus a striking kinematic consistency between the directions of intrusion propagation and avalanche runout, both oriented toward the sea. From the above results, we propose that repeated sill intrusions, such as observed on Piton des Neiges, increase the instability of a volcanic edifice. Each injection induces an incremental slip of the overlying rock mass, which may eventually end up into a landslide. Sill intrusions associated with seaward displacements of volcano flank, such as inferred for the April 2007 eruption of Piton de la Fournaise (also in La Réunion), should therefore be considered as a potential trigger of debris avalanches.
Fall meeting
San Francisco, United States

hal-01387002
http://hal.univ-reunion.fr/hal-01387002

Éditeur(s) : HAL CCSD Geological Society of America
Résumé : International audience
Porous sandstones tend to deform by the formation of low-permeability deformation bands that influence fluid flow in reservoir settings. The bands may be distributed or localized into clusters, and limited recent data suggest that tectonic regime may exert control on their distribution and clustering. In order to explore this suggestion, we performed a synthetic analysis based of 73 sets of bands, including 22 new sets measured for a reverse Andersonian regime that fill the important gap in data for this context. We find a surprisingly strong correlation between clustering and tectonic regime, where bands clearly are more distributed in the reverse regime compared to the normal regime. Together with the observed band distributions, capillary pressure data show evidence that efficient membrane seals are expected for extension, whereas pervasive permeability anisotropy is expected for contraction. Such a basic new rule concerning tectonic regime is very useful for assessment of reservoir properties where deformation bands are common but below seismic resolution.
ISSN: 0091-7613

hal-01355925
https://hal.archives-ouvertes.fr/hal-01355925
DOI : 10.1130/G37585.1

Éditeur(s) : HAL CCSD Springer Verlag (Germany)
Résumé : We present a detailed rock-magnetic and archaeomagnetic study of two brick kilns, named OSA and OSB, discovered at the location of Osterietta, in northern Italy. The magnetic properties of representative samples have been investigated to identify the nature of the magnetic carriers, their domain state and thermal stability, and investigate their suitability for archaeomagnetic determinations. Thermally stable, mainly pseudosingle domain (PSD) magnetite is identified as the main magnetic carrier. The full geomagnetic field vector has been determined for the two kilns, including directional and intensity analysis. Archaeointensities have been recovered with both the classical Thellier and the multi-specimen protocols. The multi-specimen procedure was performed with a very fast-heating oven developed at Montpellier, France. A Matlab® code for anisotropy correction during the Thellier experiment is provided. The archaeointensity results obtained from both techniques for the OSA kiln are of high quality and in good mutual agreement. For the OSB kiln, Thellier results are characterized by large standard deviation and the multi-specimen (MSP) technique was not successful. The obtained full geomagnetic field vector (declination, inclination and intensity) has been used for the archaeomagnetic dating of the two structures suggesting that the OSA kiln was for the last time used between 1761?1841 A.D. and the OSB kiln between 1752?1831 A.D., at 95% probability. This study shows that intensity determinations do not restrict the dating results when referring to the last few centuries, as this period is characterized by very small intensity variations.
ISSN: 0039-3169

hal-01236052
https://hal.archives-ouvertes.fr/hal-01236052
DOI : 10.1007/s11200-015-0413-0

Éditeur(s) : HAL CCSD Nature Publishing Group
Résumé : International audience
Mantle flow involves large strains of polymineral aggregates. The strongly anisotropic plastic response of each individual grain in the aggregate results from the interactions between neighbouring grains and the continuity of material displacement across the grain boundaries. Orthorhombic olivine, which is the dominant mineral phase of the Earth's upper mantle, does not exhibit enough slip systems to accommodate a general deformation state by intracrystalline slip without inducing damage. Here we show that a more general description of the deformation process that includes the motion of rotational defects referred to as disclinations can solve the olivine deformation paradox. We use high-resolution electron backscattering diffraction (EBSD) maps of deformed olivine aggregates to resolve the disclinations. The disclinations are found to decorate grain boundaries in olivine samples deformed experimentally and in nature. We present a disclination-based model of a high-angle tilt boundary in olivine, which demonstrates that an applied shear induces grain-boundary migration through disclination motion. This new approach clarifies grain-boundary-mediated plasticity in polycrystalline aggregates. By providing the missing mechanism for describing plastic flow in olivine, this work will permit multiscale modelling of the rheology of the upper mantle, from the atomic scale to the scale of the flow.
ISSN: 0028-0836

hal-01054315
https://hal.archives-ouvertes.fr/hal-01054315
DOI : 10.1038/nature13043

Éditeur(s) : HAL CCSD Geological Society
Résumé : Extensional basins often evolve both with the generation of normal faults at all scales, and with tilting in the hanging walls and footwalls of major structures. This paper examines the effect of regional tilting on the development of normal fault arrays in an anisotropic sequence, using the asymmetric Lodève Basin, France, as a case study. The orientation range of normal faults is found not to match that expected by continued symmetric generation of conjugate normal faults during tilting. Instead, continued generation of new faults preferentially occurred for faults dipping opposite to the direction of tilt, with propagation perpendicular to bedding. The presence of early bedding-perpendicular joints in the competent sandstone units aided propagation of these faults during tilting and this preferential asymmetric development. Bedding-parallel slip surfaces were activated as normal faults during the later stages of bedding tilting, showing complex interaction patterns with later faults downthrowing in the direction opposite to bedding tilting. Hence knowledge of the timing between tilting of the strata and deformation helps in evaluating the likely complexity of fault arrays at subseismic scales in extensional basins, and may also help in understanding the evolution of fault systems in tilted normal fault blocks at the reservoir scale.
ISSN: 0016-7649

hal-00404753
https://hal.archives-ouvertes.fr/hal-00404753
DOI : 10.1144/0016-76492006-047