Éditeur(s) : HAL CCSD Wiley
Résumé : International audience
Climatic changes result in an increased in mean temperature and in a higher incidence of extreme weather events such as heat and cold waves. For ectotherms, such as insect parasitoids, the ability to remain active under extreme climatic conditions is a significant key to fitness. The body size of individuals, and in particular their surface to volume ratio, may play a role in their resistance to thermal conditions. The thermal tolerances are investigated of two closely-related sympatric parasitoid species [Aphidius avenae Haliday and Aphidius rhopalosiphi De Stefani-Perez (Hymenoptera: Aphidiinae)] that have a similar ecology but differ in body size and phenologies. The critical thermal limits of individuals are assessed in both sexes of each parasitoid species and the influence of surface-volume ratios on their thermal tolerances. Aphidius avenae is less resistant to low temperatures and more resistant to high temperatures than A. rhopalosiphi. The lower surface to volume ratio of A. avenae individuals may help them to remain active in summer when experiencing heat waves. However, body size is not the sole factor that plays a role in differences of thermal tolerance between species and body size may not be an adaptation to extreme temperatures but rather a by-product of developmental regulation. Closely related sympatric species from the same ecological guild can have different thermal tolerances that may allow them to occur within the same habitat. The present study also highlights the importance of clearly defining how to measure critical thermal limits to determine the thermal tolerance of a species.
ISSN: 0307-6962

hal-00589094
https://hal.archives-ouvertes.fr/hal-00589094
DOI : 10.1111/j.1365-3032.2010.00758.x

Éditeur(s) : HAL CCSD Taylor & Francis
Résumé : The diamond anvil cell (DAC) is a fundamental device used to explore the properties of materials under extreme pressure and temperature (P/T) conditions. In the past years, simultaneous high P/T DAC experiments using the resistively heated DAC (RH-DAC) techniques have been developed for studying materials properties in a wide P/T range. However, the mechanical instability of metallic gaskets used for sample confinement at high P/T conditions remains a limiting factor for exploiting the accessible P/T range of the RH-DAC. In this study, we present a new gasket configuration that overcomes these limitations. It is based on an amorphous boron-epoxy mixture inserted in a rhenium gasket. We show how these gasket inserts stabilize the sample chamber over a wide P/T range, allowing monitoring sample properties using X-ray diffraction and absorption spectroscopy up to 50GPa and 1620K.
ISSN: 0895-7959

hal-01608425
https://hal.archives-ouvertes.fr/hal-01608425
DOI : 10.1080/08957959.2016.1245297
PRODINRA : 387347

Éditeur(s) : HAL CCSD ACS American Chemical Society - Publications
Résumé : International audience
ABSTRACT: In this paper, the structural, optical and thermal properties of n-type (100),p-type (100) and (111) mesoporous silicon (MePSi) are reported. The mesoporous silicon wasprepared by an electrochemical process from bulk silicon wafer. Depending on the etchingdepth, analyses show that the porosity of p-type (111) increased by 32 to 40% compared to p(100) which, in turn, increased by 22 to 48% compared to n-type (100). The structuremorphology and the abundance of Si-Ox and Si-Hy also depended heavily on the type andcrystal orientation of MePSi. The thermal properties of the MePSi layers such as thermalconductivity (κ), volumetric heat capacity (ρCp) and thermal contact resistance (Rth) weredetermined using the pulsed photothermal method. The thermal conductivity of bulk silicondropped sharply after etching, decreasing by more than twenty-fold in the case of n-type (100)and by over forty-five fold for p-type (100) and (111). According to the percolation modeldepending on both porosity and phonon confinement, the drop in thermal conductivity wasmainly due to the nanostructure formation after etching. Thermal investigations showed thatthe volumetric heat capacity (ρCp) followed the barycentric model which depends mainly onthe porosity. The thermal contact resistances of MePSi layers were estimated to be in therange of 1x10-8 to 1x10-7 K⋅m2⋅W-1.
The Journal of Physical Chemistry C

hal-01495490
https://hal.archives-ouvertes.fr/hal-01495490
DOI : 10.1021/acs.jpcc.6b13101

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Silane coating of fibers is a promising process for improving durability and adhesion of vegetable fibers used as reinforcement material in a cementitious matrix. The work presented in this paper gives an insight into the effect of combining pyrolysis treatment with silane treatment. Indeed, this study focuses on silane treatment of unpyrolyzed and pyrolyzed sugar cane bagasse fibers with an alkyltrialkoxysilane (RSi(OR′)3), S1 or a dialkyldialkoxysilane (R2Si(OR″)2), S2. The silane solutions used vary from 0.5% to 8% by volume. This paper describes the effect of two silane compounds on parameters such as the porosity, dimension, morphology and hygroscopic character of silane-coated sugar cane bagasse fibers. Preliminary studies on natural fiber reinforced composite setting time show the importance of the silane chemistry/structure, for fiber treatments with silane solution containing up to 6% (volume percent) silane. In the case of composites reinforced with unpyrolyzed bagasse fibers, setting time increases with silane coating. Combining pyrolysis and silane treatment improve the water resistance of the fibers, which become more hydrophobic.
ISSN: 1359-835X

hal-00809830
https://hal.univ-antilles.fr/hal-00809830
DOI : 10.1016/j.compositesa.2008.05.013

Éditeur(s) : HAL CCSD
Résumé : International audience
Understanding subduction rheology in both space and time has been a challenge since the advent of plate tectonics.We herein focus on "subduction infancy", which corresponds to the first 0-2 My immediately following subductionnucleation, when a newly born slab penetrates into the overriding plate mantle and heats up.The only remnants of this critical, yet elusive, geodynamic step are thin metamorphic soles, commonly found beneathpristine, 100-1000 km long portions of oceanic lithosphere emplaced on top of continents (i.e. ophiolites).In this study, we show how, during subduction infancy, transient mechanical properties of both the mantle and crustacross the subduction plate interface (during 100s ky) control and hinder the penetration of tectonic plates intothe mantle, and how this results in strong peaks of resistance and even slicing of their surface — leaving behindthin, chopped-off metamorphic slivers (i.e. metamorphic soles).These findings constrain the mechanical behaviour of the subduction plate interface (with implications for couplingprocesses and earthquake generation) as well as the properties of the crust and mantle. They also highlight the roleof fluids in enabling subduction to overcome this early resistance.
Geophysical Research Abstracts
Vienne, Austria

insu-01309386
https://hal-insu.archives-ouvertes.fr/insu-01309386

Éditeur(s) : HAL CCSD Springer Verlag
Résumé : International audience
Electrical resistivity soundings are used by geophysicists to determine the structure and composition of the Earth's crust and mantle and to explore natural resources (ore, oil, gas, water). Their interpretations in terms of composition and in-situ physical conditions depend mainly on laboratory measurements of electrical conductivity of rocks at simulated crustal conditions of temperature, pressure, saturation and pore pressures. These measurements present a numbers of limitations, in particular, in the case where conductive pore fluids are present, as in the case of deep reservoir conditions, where temperature exceeds 250 A degrees C. Here, we present a new cell capable of measuring electrical conductivity of large saturated samples at confining pressure up to 200 MPa, pore pressure up to 50 MPa, and temperature up to 500 A degrees C. The measurement cell has been developed in a commercial, internally heated, gas pressure apparatus (Paterson press). It is based on the concept of "guard ring" electrode, which is adapted to samples that are jacketed by a very conductive, metallic material. Numerical modeling of the current flow in the electrical cell allowed defining the optimal cell geometry. Calibration tests have been performed on Fontainebleau sandstones saturated with electrolytes of different conductivities, up to 350 A degrees C. The resulting electrical formation factor and temperature dependence of electrical conductivity are in very good agreement with previous studies. This new cell will improve the exploration and exploitation of deep fluid reservoirs, as in unconventional, high enthalpy geothermal fields. In particular, the investigations address possible effects of fluid-rock interactions on electrical resistivity of a reservoir host rock.
ISSN: 0169-3913

hal-00681997
https://hal.archives-ouvertes.fr/hal-00681997
DOI : 10.1007/s11242-011-9846-2

Éditeur(s) : HAL CCSD Elsevier
Résumé : International audience
Vascular resistance and tissue perfusion may be both affected by impaired vascular function and increased blood viscosity. Little is known about the effects of vascular function on the occurrence of painful vaso-occlusive crises (VOC) in children with sickle cell anemia (SCA). The aim of the present study was to determine which side of the balance (blood viscosity or vascular function) is the most deleterious in SCA and increases the risk for frequent hospitalized VOC. Microvascular function, microcirculatory oxygenation and blood viscosity were determined in a group of 22 SCA children/adolescents at steady state and a group of 13 healthy children/adolescents. Univariate analyses demonstrated blunted microvascular reactivity during local thermal heating test and decreased microcirculatory oxygenation in SCA children compared to controls. Multivariate analysis revealed that increased blood viscosity and decreased microcirculatory oxygenation were independent risk factors of frequent VOC in SCA. In contrast, the level of microvascular dysfunction does not predict VOC rate. In conclusion, increased blood viscosity is usually well supported in healthy individuals where vascular function is not impaired. However, in the context of SCA, microvascular function is impaired and any increase of blood viscosity or decrease in microcirculatory oxygenation would increase the risks for frequent VOC.
ISSN: 1079-9796

hal-01668335
https://hal.univ-antilles.fr/hal-01668335
DOI : 10.1016/j.bcmd.2015.10.005

Éditeur(s) : HAL CCSD Elsevier Masson
Résumé : International audience
The only symbiotic Mediterranean gorgonian, Eunicella singularis, has faced several mortality events connected to abnormal high temperatures. Since thermotolerance data remain scarce, heat-induced necrosis was monitored in aquarium by morphometric analysis. Gorgonian tips were sampled at two sites: Medes (Spain) and Riou (France) Islands, and at two depths: 15 m and-35 m. Although coming from contrasting thermal regimes, seawater above 28 degrees C led to rapid and complete tissue necrosis for all four populations. However, at 27 degrees C, the time length leading to 50% tissue necrosis allowed us to classify samples within three classes of thermal sensitivity. Irrespectively of the depth, Medes specimens were either very sensitive or resistant, while Riou fragments presented a medium sensitivity. Microsatellite analysis revealed that host and symbiont were genetically differentiated between sites, but not between depths. Finally, these genetic differentiations were not directly correlated to a specific thermal sensitivity whose molecular bases remain to be discovered.
ISSN: 1631-0691

hal-01546168
https://hal.archives-ouvertes.fr/hal-01546168
DOI : 10.1016/j.crvi.2013.06.008